Freezer Shelf
DOOR FEATURES
(on some models)
To Remove and Replace the Shelf:Your model may have some or all of these features. Features that
can be purchased separately as product accessories are labeled
1. Remove the shelf by lifting the entire shelf slightly and moving
it all the way to the left-hand side. Tilt the right-hand side up with the word ?Accessory.? Not all accessories will fit all models.
and out of the shelf supports.If you are interested in purchasing one of the accessories, please
call the toll-free number on the cover or in the ?Assistance or
2. Replace the shelf by inserting the left-hand end all the way
Service? section.
into the shelf supports. Then, lower the right-hand end of the
shelf and insert it into the shelf supports.
NOTE: The shelf should lower slightly and lock into place. If the Door Rails
shelf does not appear stable, make sure both ends of the shelf The door rails may be removed for easier cleaning.
are inserted into the shelf supports.
Snap-on Door Rails
To Remove and Replace the Rails:
1. Remove the rails by pushing in slightly on the front of the
bracket while pulling out on the inside tab. Repeat these
steps for the other end of the rail.
2. Replace the rails by aligning the ends of the brackets with the
buttons on the sides of the door liner. Firmly snap bracket
and rail assembly onto the tabs above the shelf as shown.
Pull-out Freezer Floor
(on some models)
To Remove and Replace the Freezer Floor:
1. Lift both back ?fences? up and out.
2. Remove the freezer floor by pulling it out about 1" (2.5 cm)
with one hand around the air tower section (center back) and Drop-in Door Rails
one hand at center front.
3. Lift up floor at rear until hooks release from cabinet and pull To Remove and Replace the Rails:
the floor out the rest of the way.
1. Remove the rails by pulling straight up on each end of the rail.
4. Replace the freezer floor by sliding the floor straight in until
2. Replace the rails by sliding the shelf rail into the slots on the
the hooks drop into place at rear of cabinet.door and pushing the rail straight down until it stops.
5. Replace ?fences? by aligning pins with socket in the floor, and
pushing down until they snap into place.
Can Racks and Door Bins
(on some models)
NOTE: Can racks may be purchased as an Accessory for some
Frozen Food Storage Guidemodels.
To Remove and Replace the Racks/Bins:
Storage times will vary according to the quality and type of food,
the type of packaging or wrap used (should be airtight and 1. Remove the rack/bin by lifting it and pulling it straight out.
moisture-proof), and the storage temperature. Seal the package 2. Replace the rack/bin by sliding it in above the desired
or container securely to prevent taste and odor transfer support and pushing it down until it stops.
throughout the product. Ice crystals inside a sealed package are
normal.
Put no more unfrozen food into the freezer than will freeze within
24 hours (no more than 2 to 3 lbs of food per cubic foot [907-
1,350 g per 28 L] of freezer space). Leave enough space in the
freezer for air to circulate around packages. The freezer door
must close tightly. For more information on preparing food for
freezing, check a freezer guide or reliable cookbook.
14 |
ACEC
WHIRLPOOL
