Using the Expression Pedal
Using the Expression Pedal
The 606 has a built-in expression pedal which can be used to control a
selected effect parameter or the volume level with your foot.
Operate the pedal
Select the module Rock the pedal
to be controlled by back and forth
while playing your
the pedal instrument.
Press the PEDAL ASSIGN key
UsingtheExpressionPedaluntil the LED corresponding toUsingtheExpressionPedal
the desired module is lit.
The LED indicators
Rock back and forth
show which module is
currently assigned to
The effect of
the pedal.
operating the pedal
The following modules
will differ, depending
can be selected.
on which module was
WAH selected in step .
Effect parameter or WAH module Try moving the pedal
DRIVE to hear the actual
Effect parameter of DRIVE module
sound change.
MOD/PITCH
Effect parameter of MOD/PITCH
(modulation/pitch) module
DLY/REV
Effect parameter of DLY/REV
(delay/reverb) module
VOL. To switch the module on and off
Overall patch volume
Push the pedal fully down. All PEDAL ASSIGN LEDs out
Expression pedal is inactive. The currently lit PEDAL ASSIGN LED starts
to flash, and the corresponding module is
The actual effect of operating the expression pedal will depend
NOTEturned off. To return to the on setting, push the Push fully down
on which effect parameter is selected for the respective module.
pedal down once more.
Y If you select a module that is set to OFF in the current patch, the Y Assignment of modules to the When VOL is
NOTE
module becomes ON when the pedal is assigned to it. If you pedal and module on/off status assigned, the pedal
later assign the pedal to another module, the previous module can be stored as part of a patch does not perform
becomes OFF again. ( ? p. 18). on/off switching.
Y In the bypass mode (effects temporarily switched off), the pedal Y The pedal sensitivity can be
is automatically assigned to VOL. adjusted ( ? p. 23).
10ZOOM 606 GUITARZOOM 606 GUITAR11 |
ACEC
OTHERS
