SHARP 61R-WP4H Repair Manual

61R-WP5H
55R-WP5H
Using the Video and Audio Input Jacks

Connecting video equipment for video playback
Y When the television is connected to video equipment as shown below, the material being played back on the
video equipment can be seen on the television screen.
Connecting a video device equipped with a video output terminal
(Front terminals of Rear Projection TV)
When noise or distortion appears on TV
caused by connecting a video game
machine, select the other setting of the
IN 2DDFC mode.
L-AUDIO-R
VIDEO EQUIPMENTS
VIDEOS-VIDEO
Signal
To AUDIO OUTPUT
orTo S-VIDEO OUTPUT
To VIDEO OUTPUTCAMCORDERTV GAME
Y The S-VIDEO INPUT terminals offer a higher quality image by accepting the image signal separated into color
Noteand brightness signals.
Y S-VIDEO INPUT terminals are for video signals only. The audio signals are connected to either IN 1 or IN 3
AUDIO terminals (left and right).
(Rear terminals of Rear Projection TV)
To AUDIO

ANT/CABLE 75OUTPUT (L/R)Video Equipment
Signal
ANT-ATo VIDEO OUTPUT
To AUDIO OUTANT-B
OUTPUT (L/R)
TO S-VIDEO OUTPUT(When your video equipment
has an S-VIDEO output terminal).
R AUDIO LVIDEO
MONITOR OUT
Signal(EXCEPT FOR HD AND
COMPONENT SIGNALS)
IN 1IN 3
SignalS-VIDEO
Signal
To AUDIO OUTPUT (L)
IN 1To AUDIO OUTPUT (R)
COMPONENTTo VIDEO OUTPUT
IN 3
YPBPRColor DifferenceUSE FOR HDTV SIGNALS ONLY.Output Jack (Component )
NOT INTENDED FOR USE WITH COMPUTERSSignal
IN 4
HD INPUT IN 3
(USE FOR HDTV SIGNAL ONLY)IN 5
To AUDIO OUTPUT (L)
To AUDIO OUTPUT (R)
CENTER INVAOR AUDIO LVIDEO
R AUDIO LSignal
To HD INPUT
(To output terminals of DTV)
Fasten with the screws
located at both ends.
14