14ENGLISHENGLISH1515
4Turn Razor Head Assembly over so that13Replace the frame.
underside is exposed.
C14Turnthewheelclockwiseuntilitlocksinto
C5Turn wheel of frame counterclockwise.place.
6Remove the frame and brush clean.
C15ReplacetheRazorHeadAssemblybackon
C7Remove and clean one cutter and comb atrazor.
a time.
16Put the protective razor head cap on the
Do not clean more than one cutter and comb at razor to protect heads.
a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, itAfter Each Use:Trimmer
could take several weeks before optimal shaving
performance is restored.1Turn razor to OFF (O) position.
8Separate the cutter from the comb.C2Push trimmer slide switch up to pop up
trimmer.
C9Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
C3Clean trimmer with the brush every time
C10Brush the slots of the comb.you use it.
For optimum performance,razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Philips Norelco Razor Head Cleaner,model
RC1776 or alcohol) and lubricated with Philips
Norelco Razor Lubricant,modelAL80,or oneC4Lubricate the trimmer teeth with Philips
drop of mineral oil (in the center of the head).Norelco Razor Lubricant (model AL80) or
This helps prevent wear of the shaving heads.with one drop of mineral oil every 6 months.
C11Replace the cutter and comb into the5Close trimmer by sliding trimmerswitch
Razor Head Assembly.down.
This razor has no other user-serviceable parts.
12Repeat the process for the other two setsAny other service should be performed by the
of cutters and combs.Philips Norelco Service Location. |
ACEC
PHILIPS
