CABINET DISASSEMBLY INSTRUCTIONS
Note:
1. Disassembly Flowchart
(1) Order of steps in procedure. When reassembling,
This flowchart indicates the disassembly steps for the
follow the steps in reverse order. These numbers
cabinet parts, and the CBA in order to gain access to
are also used as the Identification (location) No. of
item(s) to be serviced. When reassembling, follow the
parts in figures.
steps in reverse order. Bend, route and dress the
(2) Parts to be removed or installed.
cables as they were.
(3) Fig. No. showing procedure of part location
CAUTION!
(4) Identification of parts to be removed, unhooked,
When removing the CRT, be sure to discharge the unlocked, released, unplugged, unclamped, or
Anode Lead of the CRT with the CRT Ground Wire desoldered.
before removing the Anode Cap.P = Spring, L = Locking Tab, S = Screw,
CN = Connector
* = Unhook, Unlock, Release, Unplug, or Desolder
[1] Rear Cabinet
e.g. 2(S-2) = two Screws (S-2),
2(L-2) = two Locking Tabs (L-2)
(5) Refer to the following "Reference Notes in the
[2] CRT CBA
Table."
Reference Notes in the Table
[3] Main CBA
1. Removal of the Rear Cabinet: Remove screws
7(S-1), 5(S-2) and (S-3) then slide the Rear
Cabinet backward.
[4] CRT
2. Removal of the CRT CBA: Disconnect CN1501
then pull the CRT CBA backward.
2. Disassembly Method3. Removal of the Main CBA: Disconnect CN801,
CN802, CN571 and CN691 on the Main CBA then
Removalslide the Main CBA backward.
Step/
Remove/*Unhook/4. CAUTION: Discharge the Anode Lead of the CRT
Loc. Part
Fig. Unlock/Release/with the CRT Ground Wire before removing the
No.Note
No.Unplug/Unclamp/Anode Cap.
DesolderRemoval of the CRT: Remove screws 4(S-4) and
Anode Cap. then slide the CRT backward.
Rear D1
[1]7(S-1), 5(S-2), (S-3)1
CabinetD2
D4
[2] CRT CBACN15012
D5
D3CN801, CN802,
[3] Main CBA3
D5CN571, CN691
[4] CRTD4 4(S-4), Anode Cap4
?????
(1)(2)(3)(4)(5)
4-1L3800DC |
ACEC
OTHERS
