Loading
WASHER USE
Loading suggestions
For these suggested full-sized loads, set the LOAD SIZE selector
to the highest setting.
Understanding Washer Cycles
SUPER CAPACITY PLUS WASHERS
When the Cycle Control knob is set to a number and pulled out,
the washer fills (to the selected load size) before agitation and
Heavy Work Clothes
timing start. The washer begins agitating immediately after filling;
3 pair pants1 coverall
agitation occurs with the washer lid up or down.
3 shirts1 overall
During agitation, the agitator creates a continuous rollover action 4 pair jeans
(on some models) that provides a thorough cleaning of the wash
load.Delicates
3 camisoles6 undergarments
1 quilted robe2 sets of sleepwear
4 slips1 child?s outfit
Towels
10 bath towels14 wash cloths
10 hand towels1 bath mat
After agitation starts, the Cycle Control knob turns clockwise until
Mixed Load
it points to an OFF area and the cycle ends.
3 double sheets2 shirts
NOTE: The washer pauses briefly throughout each cycle. These 4 pillowcases2 blouses
pauses are normal for washer operation. 8 T-shirts8 handkerchiefs
6 pair shorts
WASHRINSE
1. Fill1. Fill
Normal Sounds
Your new washer may make sounds your old one didn?t. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
2. Wash selected 2. Rinse
timeDuring washing
When you select a small load size setting, your washer has a
lower water level. This can cause a clicking sound from the upper
part of the agitator.
3. Drain?3. Drain
No agitationNo agitationDuring drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
4. Spin4. Spin-Spray rinse
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
5. Spin
?
The Casual cycle partially 6. Off
drains, fills, agitates briefly,
and drains.
5 |
ACEC
WHIRLPOOL
