Location RequirementsElectrical Requirements
WARNINGWARNING
Explosion HazardElectrical Shock Hazard
Keep flammable materials and vapors, such as Plug into a grounded (earthed) outlet.
gasoline, away from refrigerator.
Do not remove ground prong.
Failure to do so can result in death, explosion, or fire.Do not use an adapter.
To ensure proper ventilation for your refrigerator, allow for 1??"Do not use an extension cord.
(1.25 cm) space on each side and at the top. When installing your
refrigerator next to a fixed wall, leave 2" (5.08 cm) minimum on Failure to follow these instructions can result in death,
each side (depending on your model) to allow for the door to fire, or electrical shock.
swing open. If your refrigerator has an ice maker, allow extra
space at the back for the water line connections.Before you move your refrigerator into its final location, it is
NOTE: It is recommended that you do not install the refrigerator important to make sure you have the proper electrical
near an oven, radiator, or other heat source. Do not install in a connection:
location where the temperature will fall below 55F (13°C). Recommended Grounding Method
A 115 Volt 60 Hz. (Plug 1), 220/240 Volt 50 Hz. (Plugs 2 or 3), or
220 Volt 60 Hz. (Plug 3) AC only 10-amp fused and grounded
(earthed) electrical supply is required.
1/2" (1.25 cm)
Plug 1Plug 2Plug 3Plug 4
It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off
by a switch or pull chain. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or 2" (5.08 cm)
removing a light bulb, turn the control, (Thermostat, Refrigerator
or Freezer Control depending on the model) to OFF and then
disconnect the refrigerator from the electrical source. When you
are finished, reconnect the refrigerator to the electrical source
and reset the control (Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired setting.
For Australia and New Zealand:
Your new appliance has been especially manufactured to meet all
Australian Standards and Conditions.
Some notations in the installation instructions may refer to
electrical requirements in other countries, so we draw your
particular attention to these specific notes.
Your appliance needs to be plugged into a 230/240 Volt 50 Hz.
10-amp (Plug 4) AC only earthed outlet.
4 |
ACEC
WHIRLPOOL
