IMPORTANT SAFETY INSTRUCTIONS
CAUTION:"Note to CATV system installer:
ORead all of these Instructions.This reminder is provided to call the CATV system installer?s attention to
OSave these Instructions for later use.Section 820-40 of the NEC which provides guidelines for proper
OFollow all Warnings and Instructions marked on the audio grounding and, in particular, specifies that the cable ground shall be
equipment.connected to the grounding system of the building, as close to the point
of cable entry as practical.
1) Read Instructions ? All the safety and operating instructions should
be read before the product is operated.
2) Retain Instructions ? The safety and operating instructions shouldExample of Antenna Grounding as per
be retained for future reference.National Electrical Code, ANSI/NFPA 70
3) Heed Warnings ? All warnings on the product and in the operating
instructions should be adhered to.
4) Follow Instructions ? All operating and use instructions should be
followed.
5) Cleaning ? Unplug this product from the wall outlet before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a damp cloth forANTENNA
LEAD IN
cleaning.WIRE
6) Attachments ? Do not use attachments not recommended by the
GROUND
product manufacturer as they may cause hazards.CLAMP
_
7) Water and Moisture ? Do not use this product near water for
example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in aANTENNA
DISCHARGE UNIT
wet basement; or near a swimming pool; and the like.(NEC SECTION 810-20)
8) Accessories ? Do not place this product on an unstable cart, stand,
ELECTRIC
tripod, bracket, or table. The product may fall, causing serious injury to aSERVICE
EQUIPMENTGROUNDING CONDUCTORS
child or adult, and serious damage to the product. Use only with a cart,(NEC SECTION 810-21)
stand, tripod, bracket, or table recommended by the manufacturer, orGROUND CLAMPS
sold with the product. Any mounting of the product should follow thePOWER SERVICE GROUNDING
manufacturer?s instructions, and should use a mounting accessoryELECTRODE SYSTEM
(NEC ART 250. PART H)
recommended by the manufacturer.NEC - NATIONAL ELECTRICAL CODE
9) A product and cart combination should be moved with care. Quick
stops, excessive force, and uneven surfaces may cause the product and
cart combination to overturn.15) Lightning ? For added protection for this product during a lightning
storm, or when it is left unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the product due to lightning and
power-line surges.
16) Power Lines ? An outside antenna system should not be located in
the vicinity of overhead power lines or other electric light or power
circuits, or where it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care should be taken to
keep from touching such power lines or circuits as contact with them
might be fatal.
17) Overloading ? Do not overload wall outlets, extension cords, or
integral convenience receptacles as this can result in risk of fire or
electric shock.
18) Object and Liquid Entry ? Never push objects of any kind into this
10) Ventilation ? Slots and openings in the cabinet are provided for
product through openings as they may touch dangerous voltage points
ventilation and to ensure reliable operation of the product and to protector short-out parts that could result in a fire or electric shock. Never spill
it from overheating, and these openings must not be blocked or covered.liquid of any kind on the product.
The openings should never be blocked by placing the product on a bed,
19) Servicing ? Do not attempt to service this product yourself as
sofa, rug, or other similar surface. This product should not be placed in a
opening or removing covers may expose you to dangerous voltage or
built-in installation such as a bookcase or rack unless proper ventilation
other hazards. Refer all servicing to qualified service personnel.
is provided or the manufacturer?s instructions have been adhered to.20) Damage Requiring Service ? Unplug this product from the wall
11) Power Sources ? This product should be operated only from theoutlet and refer servicing to qualified service personnel under the
type of power source indicated on the marking label. If you are not sure
following conditions:
of the type of power supply to your home, consult your product dealer ora) when the power-supply cord or plug is damaged.
local power company. For products intended to operate from battery
b) if liquid has been spilled, or objects have fallen into the product.
power, or other sources, refer to the operating instructions.c) if the product has been exposed to rain or water.
12) Grounding or Polarization ? This product may be equipped with ad) if the product does not operate normally by following the operating
polarized alternating-current line plug (a plug having one blade wider
instructions. Adjust only those controls that are covered by the operating
than the other). This plug will fit into the power outlet only one way. This
instructions as an improper adjustment of other controls may result in
is a safety feature. If you are unable to insert the plug fully into the outlet,
damage and will often require extensive work by a qualified technician to
try reversing the plug. If the plug should still fail to fit, contact yourrestore the product to its normal operation.
electrician to replace your obsolete outlet. Do not defeat the safetye) if the product has been dropped or damaged in any way.
purpose of the polarized plug._
f ) when the product exhibits a distinct change in performance this
13) Power-Cord Protection ? Power-supply cords should be routed so
indicates a need for service.
that they are not likely to be walked on or pinched by items placed upon21) Replacement Parts ? When replacement parts are required, be
or against them, paying particular attention to cords at plugs,
sure the service technician has used replacement parts specified by the
convenience receptacles, and the point where they exit from the product.manufacturer or have the same characteristics as the original part.
14) Outdoor Antenna Grounding ? If an outside antenna or cableUnauthorized substitutions may result in fire, electric shock, or other
system is connected to the product, be sure the antenna or cable system
hazards.
is grounded so as to provide some protection against voltage surges and
22) Safety Check ? Upon completion of any service or repairs to this
built-up static charges. Article 810 of the National Electrical Code,
product, ask the service technician to perform safety checks to
ANSI/NFPA 70, provides information with regard to proper grounding ofdetermine that the product is in proper operating condition.
the mast and supporting structure, grounding of the lead-in wire to an23) Wall or Ceiling Mounting ? The product should be mounted to a
antenna discharge unit, size of grounding conductors, location of
wall or ceiling only as recommended by the manufacturer.
antenna-discharge unit, connection to grounding electrodes, and
24) Heat ? The product should be situated away from heat sources
requirements for the grounding electrode.such as radiators, heat registers, stoves, or other products (including
amplifiers) that produce heat.
- 2 - |
ACEC
TEAC
