PROGRAMMER WITH NUMERICAL CLOCK
FUNCTIONSUse the + and - buttons to select the end of cooking
Length of cooking time, end of cooking, manual time required. The AUTO and length of cooking time
position, clock, timer, time programmable up to 23 symbols stay on. The relay contacts switch on. When
hours and 59 minutes.the end of cooking time coincides with the time set the
DISPLAYrelay and the length of cooking symbol switch off.
Fluorescent 4 digit 7 segment display to show the time At the end of cooking time the AUTO symbol flashes,
and cooking time.the beep sounds and the length of cooking and the
relay switch off.
AUTOMATIC OPERATION WITH LENGTH AND
END OF COOKING
Press the length of cooking time button and use the +
and - buttons to select the length of cooking time
required. The AUTO and length of cooking time
symbols stay on. The relays switch on. Press the end
of cooking button. The display shows the nearest end
of cooking time. Use the + button to select the end of
The corresponding symbol lights up to show the cooking time required. The relay and the length of
functions selected.cooking time symbol switch off. The symbol lights up
Programming is by touching the button of the function again when the time coincides with the start cooking
required. Release the button and set the time using time. At the end of cooking time the AUTO symbol
the + and - buttons in 5 second steps.flashes, the beep sounds and the length of cooking
and the relay switch off.
+ AND - BUTTON
Push the + and - buttons to increase or decrease the TIMER
time. The speed with which the time changes depends Press the timer button and use the + or - button to
on how hard the button is pressed.select the cooking time required. The bell symbol
PROGRAMMING THE TIMElights up when the timer is operating. At the end of the
programmed time the beep sounds and the bell
Pressing the length of cooking and end of cooking symbol goes out.
time buttons simultaneously, set the time required with
the + and - buttons. This operation cancels previously BEEP
saved programs and the contacts are switched off.The beep sounds at the end of a programming or a
MANUAL OPERATIONtimer function and lasts for 15 minutes.
On pressing the manual button, the relay contacts are To stop it press any function button.
switched on, the auto symbol goes out and the pan BEGIN PROGRAM AND CHECK
symbol lights up. Manual operation is only possible at The program starts about 4 seconds after
the end of automatic programming or after cancelling programming. The program can be checked at any
it.time by pressing the corresponding button.
AUTOMATIC OPERATIONPROGRAMMING ERROR
On pressing the length of cooking or end of cooking There is a programming error if the time indicated by
buttons the programmer automatically switches from the clock is between the start cooking time and the
manual mode to automatic mode.end of cooking time. A beep sounds immediately and
the AUTO symbol flashes intermittently.
SEMI-AUTOMATIC OPERATION WITH LENGTH The programming error can be corrected by varying
OF COOKING TIMEthe length of cooking or the end of cooking time. If
Press the length of cooking time and set the time
required using the + or - button. The AUTO symbol there is a programming error the relays are switched
and the length of cooking symbol stay on. The relay off.
switches on immediately. When the end of cooking CANCELLING A PROGRAM
time coincides with the time set the relay and the A program can be cancelled by pressing the length of
length of cooking symbol switch off, the beep sounds cooking time button and the - button until the display
and the AUTO symbol flashes.shows 00 00. At the end of a selected program it is
automatically cancelled.
SEMI-AUTOMATIC OPERATION WITH END OF
COOKING
Press the end of cooking button. The display shows
the current time.
PLGBPrinted in Italy 07/00 |
ACEC
WHIRLPOOL
