IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electrical shock or injury when using your air conditioner, follow these basic precautions:
Plug into a grounded 3 prong outlet.Do not use an extension cord.
Do not remove ground prong.Unplug air conditioner before servicing.
Do not use an adapter.Use two or more people to move and install air conditioner.
SAVE THESE INSTRUCTIONS
INSTALLATION REQUIREMENTS
NOTES:
Tools and PartsOn some models, the front panel is not attached to the air
Gather the required tools and parts before starting installation. conditioner. On these models, the 2 - #10 x 3D?" painted
Read and follow the instructions provided with any tools listed round-head Phillips screws (H) used to attach the front panel
will be included in the parts bag.
here.
Installation parts are supplied for double-hung windows up to
Tools Needed40" (101.6 cm) wide. A special Wide Window Kit is available
from your dealer or service center. See ?Accessories.?
Flat-blade and Phillips Tape measure
screwdriversDrill and 3D??" or smaller bit
Location Requirements
Level
IMPORTANT: Observe all governing codes and ordinances.
Through-the-Wall Installation:Check the location where air conditioner will be installed. Proper
In addition to the tools listed above, the following tools are installation is your responsibility. Make sure you have everything
needed for through-the-wall installation.necessary for correct installation.
The location should provide:
Saw1" (2.5 cm) or thicker
Grounded electrical outlet within 4 ft (122 cm) of where the
Wood preservativepower cord exits the air conditioner. lumber
#10 x 1" wood screws (7)
CaulkNOTE: Do not use an extension cord.
Free movement of air in room to be cooled.
Parts Supplied (on some models)
A large enough opening for the air conditioner.
Check that all parts are included in parts package.
Adequate wall support for weight of air conditioner. Air
conditioner weighs between 145 and 200 lbs (65 to 96 kg).
NOTE: Cabinet louvers must not be obstructed. Air must be able
to pass freely through the cabinet louvers.A
C
B
A
J
D E F G H
I
K
A.Cabinet louvers
A.Support brackets with F.#10 x 1D?" pan-head Phillips screws(8)
adjustment bolts (2)G.#10 x 3D?" round-head screws (6)
B.Foam window sash sealH.#10 x 3D?" painted round-head Phillips
C.Window lock bracket (2)screw (2) (on some models)
D.#10 x 1D?" pan-head Phillips I.Top channel
screws (6)J.Side curtains (2)
E.#10 x 3D?" washer-head K.Foam adhesive seal
Phillips thread-cutting
screws(4)
3 |
ACEC
WHIRLPOOL
