~? -i . i
them loose enough so there is about l/16? of
play. Tighten the bottom screws (Item 2).
This will pull the unit mounting flange tightly
to the window frame, sealing and locking the
air conditioner in place.
Remove the glass from the frame opening WIN[IOW FRAA(IE
selected. Clear away any hardened putty.
Before sliding unit through the casement
opening, remove the bottom window bracket 8 . Loosen the two knurled knob screws and slide
(Item 3) on both sides of the unit. NOTE:
only the top screws (Item 1) need to be the top mounting bracket (Item 5) toward the
outside of the unit, engaging the window
removed.
frame (see Figure 26). Tighten the knurled
Check the knurled knob screws to see that the knob screw in this position. This will lock the
top mounting brackets (Item 5) are retracted unit in place so it cannot tilt into the room.
to the center of the unit. They must not inter- The installation is now complete.
fere with the window frame when the unit
is installed (see Figure 23).
WE% s)taWlM OUTSIt% OF WBJOOW
6 l Lift the unit into the window opening and 9 l OPTIONAL MOUNTING INSTRUCTIONS
slide it back until the mounting frame comes
into contact with the window frame (see If the window thickness will not allow you to
use the four mounting brackets provided with
Figure 24). the unit, remove brackets and fasten flanges
of unit with sheet metal screws (see Figure 27).
These screws are not provided. The window
opening for your installation must not be
wider than 15?. |
ACEC
WHIRLPOOL
