2 l Pick the right window. First, decide what 4 l Install support bracket (Item 2) with either
room(s) you want to cool. Then choose a short or long leg down and with end of bracket
window that will allow the air-conditioned air either toward or away from window, depend-
to flow freely and directly into the room(s) ing upon construction and depth of wall and
you want cooled. Remember, it?s difficult to window sill (see Figure 6). Install sill bracket
move air around corners. If the inner sliding (Item 3). Each bracket is attached using one
window slides to the left, the unit will be 5/16? bolt, nut and washers (Items 4, 4A, 4B
installed on the right. Remove window screen and 4C).
if there is one. Choose a sliding window
that?s also near an electrical outlet. (Refer Figure 6
to the ELECTRICAL REQUIREMENT page
for type of receptacle and wiring needed.)
Do not use an extension cord. The sliding
window in which you place your air condi-
tioner should have an opening of at least
15-l/2? wide and 21 -l/4? to 40.7/8? high
(see Figure 4). For installations up to 62.
l/4? high, a special kit (Part No. 977449)
is available. For windows as low as 20.7/16?,
you must install without filler frame and
remove top angle on unit, reinstalling 3 screws 5 0 Reinstall assembled shelf with two brackets
into top of cabinet. into the window opening. Adjust brackets
This model may also be installed in steel hinged until shelf is firmly seated and sloping down
to outside. If you use a level, be sure you have
casement windows. The steel hinged case- l/2 bubble of slope. Without a level, place the
ment window must have an opening at 15-l/2? translucent panel (Item 5) on shelf. The top
wide and no more than 16-l/2? wide. of long side of the panel will be 5/16? back
from the window line (see Figure 7).
Figure 4
Figure 7
3 l Place shelf in window with tabs against the
track surface (see Figure 5).
6 l If slope back is correct, tighten all nuts se-
curely. Install lower track seal (Item 4)
shown in Figure 8. This track seal has two
holes which line up with matching screw
holes in shelf. |
ACEC
WHIRLPOOL
