WHIRLPOOL ACW144XM0 Instruction Manual

4 l Remove poly-foam block by pushing at top 8 . Ground unit to cabinet by using green ground
until bottom can be grasped with hand to wire attached to left-front corner of unit base
pull from cabinet (see Figure 4). Be careful and in lower left-hand corner of cabinet.
not to damage cabinet insulation. Fasten wire securely to cabinet using hex
head screw and nut (see Figure 6).
5 . Install plastic drain-cup spout (on cabinets
with side louvers only) into hole at rear of
cabinet. (See Figure 4.) Spout should be
facing downward through hole.
9 l If necessary, drill 3/16? diameter hole in
cabinet for ground wire (see Figure 7). Place
remaining length of wire under front lip of
base behind plastic front panel.
10 l Remove protective wrapping from control
6 . Remove paper backing from 3 seal strips and
panel. Place control panel in position and
attach them to the top flange as well as to the
insert control knobs through holes in control
right and left side of unit (see Figure 5).
panel and onto control shafts (see Figure 7).
7 l Install unit into cabinet. First, check tubing.
11 l Attach front panel by placing bottom edge on
Realign tubing if it is rubbing adjacent tubes
clips and pushing top down, then in and up.
or extending outside the flange of base unit.
Now slide unit into cabinet until it rests against
rear embossed stops (see Figure 4). Be careful
not to push against sharp fins and plastic parts. Figure 7
Figure 5
/SEAL STRIP 7