SERVICE JIG AND TOOLS
1. How to Use the Repair Jig
FFC
Use the following repair jig kit for servicing.
FFC
Part namePart code
PWB JIG
For 10 CD changerJIG-ADC-EX106SV-J00-090-010
TRANSISTOR
The kit contains the following parts (Refer to Fig-1) ;
PWB KEY
1. FFC (26P/25 cm)1 pcs
2. P.W.B. FLEX1 pcs
3. P.W.B. JIG1 pcsFig-1
4. TRANSISTOR (2SD-2395)1 pcs
5. P.W.B. KEY1 pcs
REMOVE SCREW
(1) Remove the cabinet as follows;
1) Remove the CABI BOTTOM by removing the
LED(LED201)
four screws VTT+2.6-6B (Refer to Fig-2).
(2) Remove the P.W.B. MAIN as follows;
1) Remove all terminals of the transistor Q623REMOVE MOTOR WIRE
(2SD2395) by unsoldering them.
2) Remove the two motor wires (BLU/WHT).
3) Remove the two wires (BLK/BRN) of the sensor
(PD201).REMOVE SENSOR WIRE
PWB FLEX
4) Remove the P.W.B. MAIN from the unit by
Q623
removing the four screws V+2-3.
5) Disconnect the FFC of pickup from CN101.
PICKUP FCC
6) Disconnect the PWB FLEX from CON1.
7) Remove the LED (LED201,GL380) from the
P.W.B. MAIN.
SENSOR (PS201)
8) Remove the sensor (PS201,SENR GP1S94) from
P.W.B. MAIN.
Fig-2
(3) Install the repair jig as follows;
1) Install the P.W.B. JIG into the unit and fix it with
screws. (Refer to Fig-3).
PWB JIG
Fig-3
(4) Attach the parts as follows, (Refer to Fig-4);
1) Attach the supplied transistor to the location of the
P.W.B. MAIN from which Q623 is removed in
step (2).Q623
2) Connect the supplied PWB FLEX to CON1.
Y When the CONTROL UNIT is not used, use the
P.W.B. KEY instead. (Refer to step (6), How toPWB FLEX
use the repair jig.)FFC CABLE
3) Connect the FFC cable to CON101 and pickup.
(The supplied FFC cannot be used because pitches
and number of pins are different.)Fig-4
- 4 - |