Before using the dishwasher, read the user instructions!
GB
ADG 8472Quick Reference Guide
Options
Programme selector knob
3)
Mains On / OffTime and failure display
Indicates in hours the time remaining until the
start of the wash cycle. Toward the end of the
programme, during the drying cycle, the display
will indicate the time remaining in minutes.
?F....? Identification of faults for service
technician
Start button
Switches ?on? when the dishwasher is
operating. Flashes when a fault occurs. ?Delayed start? button
Switches off at the end of the programme.The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the
button, the delayed start indicator increases by
1 hour, and after 24 returns to 00. Then press
the Start button. The dishwasher will start at
Indicatorsthe set time.
Add rinse aid4)
Antibacterial rinse
This function adds an antibacterial rinse at the
Add regeneration saltend of the wash cycle, thereby guaranteeing a
Only add regeneration salt immediately perfectly clean and sanitized load. The lamp will
light up when the function is activated. If the
before starting a wash programme.
temperature is not maintained during the
Wash cycleantibacterial cycle (e.g. if the door is opened
and remains open for a long time), the lamp will
start blinking to indicate that sanitation is not
guaranteed.
Programme
Pre-RinseWashingDrying
end
2)3)
Programme chartDetergentConsumption
ProgrammesLoading instructionsABLitreskWh Minutes
Pre-RinsecoldCrockery to be washed later.--5.00.0210
Lightly soiled crockery with no
Quickwash40°CX-13.00.7030
dried-on food.
1) 5)
Normal50°CNormally soiled crockery.XX16.01.05160
Recommended programme for
5)
Intensive70°Cheavily soiled crockery, especially XX17.01.90135
suitable for pans and saucepans.
1)Reference programme for energy label in compliance with 4)The bacteria removal efficiency has been tested by
EN 50242 regulations;the Institut Pasteur de Lille (France), based on the
2)Refer to ?User instructions?;NF EN 13697 standard of November 2001.
3)Program data obtained in conformity with European standard 5)These programmes can be used with the Antibacterial rinse
EN 50242. Values may vary in relation to usage, e.g.: option.
different loads, water temperatures - above or below 15°C -
as well as water hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
[email protected]?.
Whirlpool is a registered trademark of Whirlpool USA5019 396 91507
(We reserve the right to make technical modifications)
WH/I/K/GB
ACEC
WHIRLPOOL
