4-2. Error Codes
4-2. Error Codes
When the ADI-1150C under the normal operation detects a trouble, the error code is displayed on LCD.
The error code is indicates the description of the error by a figure of 4 digits.
It means as follows :
????
Detailes error code
2 port commands when an error occurs
The area where the error is detected (0; ADI-1150C, 1; ADI-1150C and ADI-1150D, 2; ADI-1150D)
Description of error code and their remedies are as follows :
Error codeDescriptionRemedies (probable causes)
0001A tape which was not unloaded* correctly is loading*.Perform recovery.
(V)(V)
0002A tape which was not formated* is loading*.Format a tape.
(V)(V)
0003SCSI bus reset is executed during the SCSI sequence.Confirm host computer side.
0004Subcode area is broken.Replace FM board.
0005Data in phase of SCSI protocol was interrupted.Confirm host computer side.
0006Data out phase of SCSI protocol was interrupted.
0007End of logical volume is reached.(Control of host computer failed)
0008Block management table is broken.Replace FM board.
0009Parity error occurs at data between SCSI controller and memory in FM board.
000COverflow into volume management table.(Control of host computer failed)
000DMade to recover unrecorded volume on VSIT area.
000FThe temperature sensor of power supply block detected unusual.Replace power supply block.
0010An unusual occurs at secondary circuit (+5 V path).
0011An unusual occurs at secondary circuit (+24 V path).
0012An unusual occurs at primary circuit.
0013Cooling fan broke down.Replace cooling fun.
1x1BDownload to DRIVE CPU failed.Replace FM board.
1x1CWrite to flash ROM of DRIVE CPU failed.
1x23Read/write to tape is not completed correctly even if the regular retryCheck ADI-1150D if no abnormality is
is executed.found by troubleshooting (section 4-3).
1x24When tape read/write started, servo lock failes.Check ADI-1150D.
1x25During tape read or write, servo lock lost.
1x26Tape positioning error occured.
1x3ADATA READY (data transmission start) signal from ADI-1150D
was waited, but it was timeout.
1x3CThere is an area that ID was not recoreded in READ operation.
* (V) : Vender Unique
Continued to next page
4-2 |
ACEC
SONY
