TROUBLESHOOTING GUIDE
If a fault occurs, before contacting our After-Sales Service, make the following
checks to try and remedy the problem.
Restart the wash programme to see if the
fault repeats.Other fault signals depending End
Press theStar buttotn for about 5 seconds on the model installed:
until the Start indicator lamp switches off.
The programme progress indicator lamp on
Briefly press the Star buttont.
the control panel flashes:
If the malfunction persists, switch off the
Detach the lower spray arm. Check crockery and
appliance and turn off the water tap. Call our
cutlery have been loaded correctly and that the
After-Sales Service.
lower spray arm has been correctly fitted.
The appliance will not switch on.
Crockery still dirty after washing:
Power plug properly inserted in the mains
Have you selected the correct programme?
socket?
Have you used the correct amount of
Power failure?
detergent?
Have you switched the dishwasher on?
Filters clogged or incorrectly assembled?
Have you pressed the Start button?
Spray arms blocked or nozzles clogged?
Have you set the delay timer (if fitted)?
Salt container cap screwed down?
Tap turned on? If not:
Crockery loaded correctly? (the water jets
Turn on the water tap.
Make sure the water hose filter is notmu st spray the entire surface of all items).
clogged.Spotted crockery:
To do this, turn off the water tap, disc Water haonnect rdness duly checked and
the water hose, clean the filter, reconregunect lated?
the water hose to the tap and turn on the tap. Salt container empty?
Filters clogged?
Insufficient detergent?
Crockery loaded upside down?
Spotted glasses and cutlery:
When loading large items in particular, make
Too much rinse aid? (Adjust the rinse aid
sure the water circulates and does not collect
regulator to a lower setting).
inside them.
Note:
Door closed properly?
On some models when the Star but tton is
Fault indicated?
pressed, a pre-rinse cycle is performed prior to
The Start indicator lamp flashes:
the actual wash programme to regenerate the
water softener system.
AFTER-SALES SERVICE
Before contacting our After-Sales Service,If, after carrying out the
1. Try to remedy the problem above checks the
malfunction persists,
(See ?Troubleshooting guide?).
2. Switch off the dishwasher and restarcat tll our Ahe fter-Sales
Service and specify:
wash programme to see if the fault repeats.
the nature of the
problem,
the appliance type and
model,
the service number
(the number after the
word Service on the adhesive label) located
inside the door on the right hand side,
your name, address and telephone number.
21 |
ACEC
IGNIS
