3gb94602.fm Page 61 Monday, April 14, 2003 8:35 PM
BEFORE USING THE DISHWASHER/
CONNECTIONS
1. Removing the packaging and controls: For appliances with water-stop system only: if the
After unpacking, make sure that the dishwasher is water connections are made correctly, the water-
undamaged and that the door closes correctly. stop system safeguards your home against damage
If in doubt, contact a qualified technician or your caused by flooding.
local retailer.
4. Electrical connection:
? Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, as ? Closely adhere to local Electricity Board
regulations.
they are potentially dangerous.? Voltage information is shown on the rating plate
? This dishwasher has been factory tested to ensure
mounted inside the door on the right hand side.
it functions correctly. ? The appliance must be earthed as prescribed by law.
Such testing may leave slight water marks that will
disappear with the first wash.? Do not use extension leads or multiple adapters.
? Before carrying out maintenance, disconnect the
2. Water and electrical connections:mains plug.
All water and electrical connections must be ? If necessary, the power cable may be replaced with
carried out by a qualified technician in compliance one the same obtained from our After-Sales
with the manufacturer's instructions (refer to the Service. The power cable must only be replaced by
enclosed installation booklet) and current local a qualified technician.
safety regulations.
The appliance must only be used in the household
? For Austria: if the apparatus is series connected to
for the prescribed uses.a fault current switch, this must be sensitive to the
pulsating current.
Do not use the dishwasher if it has been damaged in
transit. Consult your local retailer or our After-Sales
Service.
(Refer to the separate installation
instructions booklet)
3. Water inlet and drain:
? Observe any special regulations issued by your local
Water Board.
Water supply pressure: 0.3 - 10 bar.
? Make sure the inlet and drain hoses are kink-free
and are not crushed.
? If the hose length is not sufficient, please contact
your local dealer or our After-Sales Service.
? The inlet hose must be securely clamped to the
water tap to prevent leaks.
? The inlet water temperature varies according to
the model installed. Inlet hose marked ?25°C Max?:
maximum temperature 25°C.
All other models: maximum temperature 60°C.
? When installing the appliance, make sure the drain
water discharges correctly (if necessary, remove
the wire gauze from the sink siphon).
? Fix the drain hose to the spigot with a clamp to
prevent it from coming off during operation.
61
Black process 45.0° 100.0 LPI |