HOW TO USE THE DISHWASHER
Close the dishwasher door and turn on
the water tap.
1. Press the ON/OFF button to switch on the
dishwasher. Select the programme required
by turning the programme selector knob.
The corresponding indicator lamp will
illuminate.1
If required, select any additional functions.
2. Press thStarte button to start the selected
wash programme. The Stinardit cator la mp
will illuminate. Once set, the programmed data
cannot be altered by turning the programme
selector knob or pressing the buttons.2
Note: Once the Star buttotn has been pressed,
the dishwasher memorises all the programmes
selected. The selected programmes are also
saved in the event of power failure.
3. To change the programme selected, press
the Star buttton for about 5 seconds until the
Start indicator lamp switches off. Select a
new programme using thprogramme e
sector knob and press the Start button. 3
The End indicator lamp (if fitted) illuminates
briefly andSt the art indicator lamp switches
off to indicate the end of the programme.
4. Turn the programme selector kn counobter
clockwise to the ?0? position to switch off the
dishwasher (only after theEnd indicat or lamp
has illuminated briefly or theStar inditcator 4
lamp has switched off). All the indicator
lamps switch off.
Note: If the dishwasher is switched off
during a wash programme, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
44 |