UNPACKING AND INSTALLATION
TRANSIT SECURITY BARS HYDRAULIC CONNECTION
Before starting the machine up, the transport securityThere should be a COLD WATER tap near the washing
bars must be removedas follows:machine with a screwing on connection pipe of 3/4 gas for
You are advised to keep all the transport security bars inthe water supply, a sink, a wash basin or a drainage system
case the appliance has to be transported again.in the wall.
1. Unscrew and remove thePreviously check if:
three rear screws by
means of a key.Nit is not a hot water tap.
Nthe running water is clean. If not, run off a
reasonable amount of water to flush out any debris
that may have collected in the pipes.
Have the permanent drainage system in the wall checked
by a plumber.
Place the enclosed rubber joint, delivered in a plastic bag
together with the appliance (A), at the very end of the inlet
hose and carefully screw the pipe to the tap taking care not
2. Lean the appliance backto damage the screwdrive and fix the nut well on to the end
on the rear and fit one ofin order to avoid leaking.
the polystyrene angles
between the applianceIf necessary turn the hose
and the floor.adequately by unscrewing
the nut at the rear of the
Make sure the hosesappliance.
are not squashed.
3. Carefully remove the
plastic bags on the rightNow tighten the nut anew to avoid leaks. (Open the tap and
and the left, pulling themasure that it does not leak and close it again.)
to the centre of the
appliance.Place the discharging hose
in a washbasin or sink with
the aid of the bent piece
delivered separately. The
bent piece has to be
entered into the tubeOs
mouth in order to assure
the support. Aforesaid
piece allows the hose to be
4. Place the machine in anfixed to the wall by means
upright position andof an opening on the upper
remove the three plasticpart and that way the hose
bolts.does not move and its
falling is avoided.
5. Plug the 3 holes with the
plastic plugs which you
can find in the envelope
containing the instruction
booklet.
4 |
ACEC
ZANUSSI
