Remote Control Unit
The receiver and some other TEAC components which haveAM Indoor Loop Antenna
mark on the front panel can be operated by the provided "UR"
A high-performance AM loop antenna provided with the receiverremote control unit.
is sufficient for good reception in most areas.
When operating the remote control unit, point it towards the
Connect the loop antennaOs wires to the AM antenna terminals as
shown.REMOTE SENSOR on the front panel of the receiver (or other TEAC
Place the antenna in a suitable location and rotate it to thecomponent).
direction which gives the best reception, as far away as possible
from the entire system, speaker cords and the power cord, to< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there are
prevent unwanted noise.any obstacles between the unit and the remote control.
How to stand the antenna< If the remote control unit is operated near other products
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other products may
operate incorrectly.
Battery Installation
While pressing in the direction of the
arrow illustrated in figure 2b, insert
the antenna claw into the slot as
illustrated in figure 2a.
1Remove the battery compartment cover.
2Insert two OAAAO (R03, UM-4) dry batteries. Make sure that the
batteries are inserted with their positive O+O and negative O_O
poles positioned correctly.
3Close the cover.
Battery Replacement
If the distance required between the remote control unit and main
unit decreases, the batteries are exhausted. In this case replace
the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive O+O and
negative O_O polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long time
(more than a month), remove the batteries from the remote
control unit to prevent them from leaking. If they leak, wipe
away the liquid inside the battery compartment and replace the
batteries with new ones.
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
4 |
ACEC
TEAC
