Troubleshooting
If you have problems with your system, look through this chartRemote control does not work.
and see if you can solve the problem yourself before calling youreIf the batteries are exhausted, change the batteries.
dealer or TEAC service center.eUse remote control unit within the range (5m/15ft) and point
at the front panel.
eClear obstacles between the remote control unit and the
No powermain unit.
eCheck the connection to the AC power supply.eIf a fluorescent light is near the unit, turn it off.
eCheck the operation of your remote control unit. (Turn it on
and select an appropriate device.)
No sound or only a very low-level sound is heard.
eCheck that the speakers and components are connected
securely.If normal operation cannot be achieved, unplug the power cord
eCheck the operation of the connected component.from the outlet and plug it again.
eCheck the audio output setting of the connected
component.
eAdjust the volume.
eIf muting is on, press the muting button () on the remote
control unit.
The sound is noisy.
eThe unit is too close to a TV set or similar appliances.
Relocate the unit , or turn them off.
To reset the unit
Sound cuts off during listening to the music or no sound even
In the following cases, function buttons may not work properly.
though power is ON.
1) When the system is damaged by some electrical shock.
"PROTECT" is displayed
2) When the power is irregular or has electrical noises.
eSpeaker impedance is less than prescribed for this unit.
In such a case, reset this unit by quickly (technically, at intervals
Use a speaker with an impedance of between 4 and 8 ohms,
of 0.7 second) pressing the following two buttons on the front
preferably 6 ohms.
panel in the order indicated.
eTurn the power off and turn it on again. Then reduce the
volume.
Cannot select the desire surround mode
eCheck the source to play for compatibility (DTS, Dolby
Digital, etc).
eCheck the speaker configuration settings.
Low bass response.
eSpeaker polarity (+/_) is reversed. Check all speakers for
correct polarity.
eTurn on your powered Subwoofer.
Cannot listen to any station, or signal is too weak.
When you press the buttons at proper intrevals and the unit is
eTune in the station properly.
reset, the currrent date is momentarily displayed and the unit
eIf a TV is near the unit, turn it off.
is automatically switched on.
eInstall the antenna again after locating the best reception
position.
* Preset your favorite radio stations again as they are erased
eAn external antenna may be required.
from memory. Ditto for your speaker configuration settings.
The tuning step is not consistent with broadcasts in your
country.
eTo correct the tuning step, hold down the FM/AM or BAND
for more than 4 seconds.
46
ENGLISH |
ACEC
TEAC
