AG-3200P-EN-1.fm Page 20 Tuesday, May 28, 2002 2:54 PM
BSelect input modeGStart editing
Select ?F-1? ?when connecting the other component to the Load the source cassette and engage the Play mode of the other
audio/video input connectors on the front panel.component, then press PLAY (4) on the VCR. Insert Editing begins
Select ?L-1? ?when connecting the other component to the at this point.
audio/video input connectors on the rear panel.I Insert Editing stops automatically when the counter reaches
Press AUX or CH+/- on the Remote. Or push the JOG dial, then ?0:00:00?, and the VCR enters the Play mode.
turn it to the left or right.
To stop editing any time during recording
CSelect video input connectorPress STOP (8) on the Remote or STOP/EJECT (0) on the
Select the appropriate mode depending on the connector being VCR, then engage the Stop mode of the other component.
used ( pg. 16).
NOTES:
When using S-VIDEO input connector on the front panel, set I Insert Editing is not possible with a cassette whose record safety
?FRONT AUX INPUT? to ?S-VIDEO?.
tab has been removed.
When using S-VIDEO IN connector on the rear panel, set ?REAR I The recording speed (SP/EP) is determined by the previous
AUX INPUT? to ?S-VIDEO?.
When using VIDEO input connector on the front panel, set recording to be replaced. If the recording speed changes on the
tape to be edited while editing the tape, the inserted picture will
?FRONT AUX INPUT? to ?VIDEO?.be distorted where the recording speed changes.
When using VIDEO IN connector on the rear panel, set ?REAR
I When you edit a tape, a small portion of the recording
AUX INPUT? to ?VIDEO?.preceding to the editing start point will be erased from the
DSelect edit modeedited tape.
Set the edit mode to ?ON? for the VCRs if such a mode is
equipped.
I On this VCR, set ?PICTURE CONTROL? to ?EDIT? ( pg. 14).
ELocate end point
Load the cassette to be edited into the VCR and press PLAY (4),
then press PAUSE (9) when you find the end of the scene for
which you want to edit.
Press C.RESET so that the counter reading becomes ?0:00:00?.
FLocate start point, and engage Insert Editing mode
Press REW (3), then press PAUSE (9) when you find the
beginning of the scene for which you want to edit, then press
INSERT.
I The VCR enters the Insert Editing Pause mode. ?? and ?$?
light on the display panel.
I If you want to perform AV Dubbing and replace the picture,
Hi-Fi audio soundtrack and normal audio soundtrack all at the
same time, after you press INSERT, press A.DUB also.
CONTINUED ON NEXT PAGE
? 20 ?
Page 20May 28, 2002 2:53 pm |
ACEC
PANASONIC
