Adjusting Airflow to BurnerInstalling Grill Module
1. Remove grates.Grill module must be installed in right module reservoir.
2. Remove module from range.Before operating grill module for first time, lightly coat top
? See Removing Two Burner Module section.of grill grates with cooking oil to prevent sticking.
3. Remove module top by pressing on two release
buttons on the side of the module simultaneously
while lifting up module top.
WARNING4. Replace module without top in module reservoir.
To avoid risk of personal injury, all controls must be in
off position before removing or installing modules.? See Installing Two Burner Module section.
5. Loosen air shutter lock screw.
? See Operating Two Burner Module section.
1. Turn all control knobs to OFF position.
2. Place grease pan into module reservoir as shown
below.
6. Open or close air shutter depending on appearance
of burner flame.
7. After burner flame is properly adjusted, tighten air
shutter lock screw.
8. Remove module from range, replace module top, and
reinstall in range.
3. Remove grill grates from grill module.Adjusting Low Burner Flame Size
4. While holding module with air shutter openings
towards rear, push module onto orifices.1. Push and turn burner control knob to LITE position.
? Burner sparks until gas ignites.
? Module must cover orifices completely.2. Set flame to low position.
5. Place module into module reservoir.
? When module is installed correctly, it should not3. Remove burner control knob.
slide.
6. Replace grill grates.
Removing Grill Module
1. Turn all control knobs to OFF position. Allow grill
module to cool.
4. Turn screw in center of burner control stem using2. Remove grill grates.
small standard screwdriver until flame is adjusted.3. Locate tab on front of module.
5. Replace control knob.4. Lift module up and slide out while holding
6. Push and turn burner control to test burner flame.by front tab.
5. After module clears orifices, remove module
from range.
15 |
ACEC
WHIRLPOOL
