AJ 3140/00 page 6
ControlsInstallation
EnglishCONTROLSMAINS CONNECTION
1 RADIO1. Check if the mains voltage as shown on the type
to switch radio mode ON/OFFplate on the back of the set corresponds to your
2 ALARM 2 mode selectorlocal mains supply.
If it does not, consult your dealer or service
BUZ(zer) - to activate buzzer for Alarm 2 setting
RAD(io) - to activate radio for Alarm 2 settingorganisation.
OFF - to switch off Alarm 22. Connect the mains plug into the wall socket.
� The mains supply is now switched on and the
3 ALARM 1 mode selectornumbers on the display will start to flash.
BUZ(zer) - to activate buzzer for Alarm 1 settingYou will need to set the correct time.
RAD(io) - to activate radio for Alarm 1 setting
3. To disconnect the set from the mains completely,
OFF - to switch off Alarm 1withdraw the mains plug from the wall socket.
4 Speaker
5 SLUMBERPOWER FAILURE
to set/activate slumber time
6 7 fast up:� When a power failure occurs, the complete clock
to adjust the hours and minutes for TIME andradio will be switched off.
ALARM TIME� When the mains supply returns, the numbers on the
display will start to flash and you will need to reset
7 4 slow down:the correct time on the clock.
to adjust the hours and minutes for TIME and
� To retain the clock time and the set alarm time(s) in
ALARM TIMEthe event of an power failure or disconnection, you
8 ALARM 1can insert a 9 volt battery (not included), type 6F22,
to adjust/review ALARM 1into the battery compartment:
should there be a power failure, the clock will
9 ALARM 2
to adjust/review ALARM 2continue to function. However, the time will not be
illuminated on the clock display, as the use of the
0 TIME
battery is strictly to retain both the set clock and
to adjust clock timealarm time(s) only, where actual operation of the
! RESETalarm and radio is excluded.
to stop the active alarm for 24 hoursAs soon as the power is switched on again,
the display will indicate the correct time.
@ SLUMBER OFF/REPEAT ALARM
to switch off the alarm for 7 minutes1. Before inserting the battery, connect the mains
plug to the wall socket.
# Dial scale2. Place the battery into the battery compartment
$ VOLUMEon the underside of the clock radio.
to adjust the sound level� Replace the battery once a year, or as often as
necessary.
% Display
^ BAND
to select FM-MW or LW waveband
& TUNING
to tune to radio stations
6 |
ACEC
PHILIPS
