XP AJ 3380/00.3 22-06-2000 12:14 Pagina 5
CLOCKALARM
Clock display3. Release the 7 or 4 buttons when you have
English
The time is displayed using the 24-hour clockreached the correct setting.
system.4. Adjust the clock control to the RUN position
to return to clock time display.
Adjusting the time
� To review your set alarm time, adjust the
1. Adjust the clock control to the TIME SET
clock control to the respective ALARM 1 or
position.
ALARM 2 position.
2. Press and hold down the 4,7 buttons to set
5. To select the alarm mode you wish to be
and adjust both the hours and the minutes.
awoken by, set the respective ALARM 1or
� With your finger held down on 7, the time
ALARM 2 switch to RAD or BUZ.
will increase rapidly and continuously from
� If you have selected the radio mode, make
minutes to hours. Release 7 when you
sure you have adjusted the volume loud
reach the approximate time setting.
enough to wake you.
� Pressing 4 will allow you to adjust the
� The 2 buzzers are at a set volume and
time slowly back minute by minute.
cannot be adjusted. BUZ on ALARM 1 is a
3. Release the 7 or 4 buttons when you have
low tone buzzer while BUZ on ALARM 2 is
reached the correct setting.
high tone.
4. To safeguard the clock time from being
accidentally adjusted, turn the clock control to
ALARM OFF
the RUN position.
You can switch off the alarm in three ways:
SETTING THE ALARMUnless you choose to cancel the alarm
completely, the ALARM RESET option will be
General
automatically selected after 59 minutes from the
If you wish to use the alarm, then you should
time your alarm first goes off.
first set the alarm time. Two different alarm
times are possible. This can be useful when, forAlarm reset
example, you need to be awakened at a differentIf you want the alarm mode to be stopped
time during the week and at the weekend. Thereimmediately, but also wish to repeat the alarm
is also the choice of two modes for waking youcall at the same time for the following day:
up: by buzzer or radio. The display also indicatesY Press ALARM RESET during the alarm call.
whether you have switched on the alarm (s), and
Repeat alarm
these indicators will light up respectively next to
This will repeat your alarm call at 7 minutes
ALARM 1 and ALARM 2 on the display.
intervals.
Y Press SLUMBEROFF/REPEAT ALARM.
ALARM ON
Y Press SLUMBEROFF/REPEAT ALARM again
1. Adjust the clock control to the ALARM 1 orduring the next call if you wish to repeat the
ALARM 2 position.alarm call.
2. Press and hold down the 4, 7 buttons to setY If, however, you do not press SLUMBER
and adjust both the hours and minutes.OFF/REPEATALARM again, the alarm will
� With your finger held down on 7, the timesound for 59 minutes before turning itself off.
will increase rapidly and continuously fromYour alarm time setting will then
minutes to hours. Release 7 when youautomatically enter the ALARM RESET mode
reach the approximate time setting.to sound at the same time next day.
� Pressing 4 will allow you to adjust the
time slowly back minute by minute.
5 |
ACEC
PHILIPS
