XP AJ 3940/3941/17.1 29-03-2001 10:57 Pagina 7
CONTROLSINSTALLATION
# / §
� to adjust clock/alarm times;TOP, FRONTSIDE and BACK PANEL
� to set the day
1 SLUMBER - to adjust the slumber timeEnglish� to skip CD tracks/search for a particular
2DAY/REPEAT ALARMpassage
� to switch off the alarm for a 9 minute� to set a CD track for ALM 1 or ALM 2 in
periodTRACK SELECT mode
� to set the day for weekend sleeper� to select the buzzer melody for ALM 1 or
activationALM 2
3 24 HR RESET - to stop the active alarm for$ WEEKEND SLEEPER - to deactivate ALM1
24 hoursor ALM 2 for the weekend
4 PUSHYOPEN - to open/close the CD door% TIME - to set the clock time
5 TRACK SELECT - to select/review TRACK^ BUZZER - to select the buzzer mode for
SELECT number for ALM 1 or 2ALM 1 or 2 - to select the buzzer melody
6 DISPLAY - to show the clock/alarm times& RADIO ON
and status of the set� to switch on the radio
7 PLAY 2 - to start CD playback
8 9 OFF� to select radio mode for ALM 1 or ALM 2
� to stop CD/Radio/Slumber function* BAND - to select FM/AM waveband
� to cancel the TRACK SELECT setting( p - 3.5 mm socket for plugging in
� to cancel alarm setting(s)headphones/active speakers
9 DBB - for an enhanced dynamic bass boost) VOLUME - to adjust the sound level
0 ALM 2 - to set/review/switch off ALM 2! TUNING - to tune to radio stations
! BRIGHTNESS - to change the brightness of" Battery door - for backup batteries
the display illuminationL Pigtail antenna - antenna to improve FM
@ ALM 1 - to set/review/switch off ALM 1reception
d Power cord - for AC power supply
POWER CONNECTION
1. Check if the power supply as shown on the type plate (on the
bottom of the set) corresponds to your local power supply. If it
does not, consult your dealer or service center.
" If your set is equipped with a voltage selector, found on the
bottom right-hand corner of the set, adjust the selector to
correspond with your local power.
2. Connect the power plug to the wall socket.
� The power supply is now switched on and the numbers on
the display will start to flash. You will need to set the
correct time.
3. To switch off the power supply completely, pull the power plug
out of the wall outlet.
7 |