Note for loading envelopes
8. LOADING PAPER
?When loading envelopes into the paper tray, load them in portrait
Follow the steps below to load paper into the paper tray or bypass
direction.
tray. For detailed information of paper types.
?Do not use non-standard envelopes, envelopes with clasps, or win-
dow envelopes.
LOADING PAPER INTO THE PAPER TRAY?Be sure to select each of Com10, DL, C6, and Invitation A2 on the
1. Remove the output t,r and ay open the front lid of paper .tray paper size setting of the printer driver.
(For printing only)
When loading index cards, postcards or birthday cards
Set the paper knob to the "Thick Paper" setting.
Set guide up, and then fit gui and de against the loaded
cards.
Be sure to load in
portrait direction.
2. Open the guides wide (, ) enough to allow easy loading of the
paper.
Note:? Most paper and envelopes will be fed correctly from the
paper tray. However, if paper or envelopes are particularly
stiff or heavy they should be fed one at a time through the
bypass tray. This will avoid wrinkling or misfeeding.
5. Close the front lid of the paper tray by firmly pushing on it?s right
edge.
Note:? If the length of the paper is longer than the tray, keep the
front lid of the tray open while printing.
3. Load the paper.
6. Attach the output tray.
Load the paper so that the side to be printed or copied onto is face
down into the paper tray. Push the paper to the right and rearPlace this projection
toward the unit.
sides of the tray.
7. Pull out the output tray extension to the paper size, and then raise
the paper stop guide.
4. Move the guides (, ) to touch the edges of the paper.
Note:? Be sure that paper is free of rips, dust, wrinkles, and curled
(For printing only)or bent edges.
When loading envelopes
?Make sure all the paper in the stack is the same size and
Set the paper knob to the "Thick Paper" setting.type.
Load the envelope face down with the flap to the right, and t? henFan the paper and tap it against a flat surface to ensure it
adjust the paper guides to the width of the envelope.is even before loading into the unit.
?The paper tray can hold up to 150 sheets of 20lbs.
(75g/m2) plain paper. Be sure to keep the total thickness of
the loaded paper stack below 15mm.
?Ensure there is no space between the paper and the
guides and that the guides are not set too tight against the
paper causing the paper to buckle.
?The paper knob should always be set to the "Normal Pa-
per" setting except while printing on thick paper. |
ACEC
SHARP
