Editing
Editing with the RS-232C remote control
Using the RS-232C remote control (AJ-A250), which is available as an optional accessory, two
unitsNa player VTR and a recorder VTRNcan be controlled directly from the controller to enable
speedier and more efficient assemble editing, insert editing and other editing jobs.
Preparation:
OAs shown in the figure below, connect the player VTR and recorder VTR to the RS-232C
remote control.
Player VTR: AJ-D250
To RS-232C connector
INPUT
To RS-232C
connector
OUTPUT
RS-232C
remote control
Recorder VTR: AJ-D250(AJ-A250)
OSet the INPUT SELECT switch to the position which corresponds to the connection with the
player VTR.
S-VIDEO:When connected to the S-VIDEO IN and AUDIO IN connectors
LINE:When connected to the VIDEO IN and AUDIO IN connectors
OSet the LOCAL/MENU/REMOTE switch to the REMOTE position.
<Note>
The disturbances in the pictures during preview can be alleviated by inputting a black burst
signal or other reference signal to the REF VIDEO input connectors of the player VTR and
recorder VTR.
Operation:
Use the RS-232C remote control to control both the player VTR and recorder VTR.
Read the operating instructions of the AJ-A250 carefully.
<Note>
When the AG-A571 is to be used as the remote control, select D230 as the setup menu item
No.205 O232C ID SEL� setting. (See page 30)
The unit can be used as the player VTR.
35 |
ACEC
PANASONIC
