Entering the edit points
1Search for the edit IN point by performing the jog or shuttle operation.
Establish the still picture mode at the desired position.
Refer to page 29 for details on the jog/shuttle operations.
2Press the SET button while holding down the IN button.
The edit IN point is now entered.
The edit IN point value now appears on the display.
3Search for the edit OUT point by performing the jog or shuttle operation.
ENGLISH
Establish the still picture mode at the desired position.
Refer to page 29 for details on the jog/shuttle operations.
4Press the SET button while holding down the OUT button.
The edit OUT point is now entered.
The edit OUT point value now appears on the display.
INPUT SELECTEJECT
ONVIDEOY PB PRCMPSTSDTI(V&A)SDI
AUDIO ANALOGAES/EBUUSER SETSDI
AUTO OFF
OFF
POWER
CH CONDITION
TC MODECONTROL
TCINTTAPEREMOTEPUSH
METERTC/CTLJOGSHTL
FULL/FINESLOW
UBEXTEELOCALREVFWD
LSTAND BYPLAYERRECORDER
MONITOR SELECTTC SET
RSHIFTADJ STARTRESET
WDVSCH CF
SERVOREC INHIBIT
LEVELCH1CH2CUEVIDEOVIDEO CH1CH2CUETCEDITPLAYREC
RECASSEMBLEINSERT-
APREVIEWA
HEADPHONESREVIEWPREROLLIN�+TRIMOUTREWSTOPFFAUTO EDIT
PB
INSETOUT
PULLPULL
OPENPULL FOR VARIABLEOPEN
2, 41, 3
Match frame processing function
When using two VTRs for editing, a total of four edit pointsNnamely, the playerOs IN and OUT
points and the recorderOs IN and OUT pointsNneed to be entered. However, since the last
edit point is calculated automatically, only three of these edit points must be entered.
Negative duration function
This function is used by combining setup menu No. 301 (IN/OUT DEL) and No. 302 (NEGA
FLASH) described on page 64.
35 (E) |