4. CONNECTIONS
Antenna cord: To vehicleOs antenna
GreenGreen/BlackVioletViolet/BlackPower antenna cord (blue)
LineLine
+�+�
Left speakerRight speaker
Ground cord (black)
Power supply cord (red)Ignition key
Memory back-up power cord (yellow)
5. OPERATIONS
1. OFF/VOL (Volume)8. PRESET STATION Swtiches (1-6)
Power ON/OFF : The power is turned OFF when the control isA total of 6 MW and 12 FM stations can be preset into the six
roated counterclockwise as far as it will go ; it is turned ONpreset station switch. When any one of 1 to 6 switch is
when the control is rotated clockwise.pressed for 2 seconds or longer, the frequency currently
being received is written to the preset memory associated
Volume adjustment : When the control is rotated clockwise
with the switch pressed. When any one of 1 to 6 switch is
past the point at which the power is turned on, the volume
pressed for less than 2 seconds, the contents of the preset
will be increased. Conversely, when it is rotated
memory is called as soon as the switch is released.
counterclockwise, it will be reduced.
9. TONE Control
2. BALANCE Control
Set the TONE response by rotating the TONE CONTROL.
Balance adjustement : The volume balance between the left
Tone control is used to adjust high-frequency quality of the
and right channels can be adjusted. Rotate it counter-
sound.
colckwise then the volume at the right is low or rotate it
clockwise when the volume at the left is lowand adjust theBasic operation
balance between the left and right channels. Nomally the1. Turn the unit on by means of the ON/OFF VOLUME control,
control is kept at its center(clickstop) position. After havingand adjust it to obtain the desired volume.
performed the adjustment, release the control.2. Press BAND selector to change the radio mode from FM, to
MW.
3. EJECT/Fast Forward Switch
3. Press the TUNING button to tune in the desired station.
Pressing this switch sets the tape to the fast forward mode,
When this is to the right, the reception requency is
the tape run in the same direction quickly. To release, press
increased, while pressing it to the left reduceds the
this switch and this will return the tape to normally play back.
reception frequency.
Pressing this switch more will cause the tape to be ejected
4. Use the volume, BALANCE, TONE controls to adjust the set
from the loading slot.
to your liking.
4. Tape Loading SlotY Your set is in the tape playmode if a cassette tape is loaded
Load the cassette tape with the side of the tape visible to theinto the tape deck.
right. Once you insert the tape it will automatically start
Memory back-up power supply
playing.
This unit is provided with a memory back-up power supply
5. LCDwhich functions retain the contents of both the preset station
memory, which is used to store the preset stations, and the
6. BAND Switch (FM1, FM2, MW)last station memory. Which is used to store the station which
Push this button to select desired Radio band FM1, FM2, MW.was tuned in before the Power was switched off.
7. Manual tuning UP/DOWN
Use manual tuning when stations are too weak to be picked
up by seek tuning.
* Each press of the (T-UP) side of button increases the
frequency in 50kHz steps in the FM band, 9kHz in the MW
band. Pressing the (T-DN) side of button decreases the
frequency, Holding down either side of button changes the
frequency at high speed.
3 |
ACEC
DAEWOO
