Parts and their functions
$ Camera control unit rear panel
ABCD[
RET1RET2RET3RET4OUT1OUT2OUT3OUT4/PMY / GPb / BPr / RPM
HDHD
SDI INPUTSDI OUTPUTOUTPUT
RET1RET2RET3RET4OUT1OUT2OUT3OUT4RET1RET2PROMPT
SDSD
EFGH
SDI INPUTSDI OUTPUTINPUT1212
WFM1WFM2PM1PM2VBS1VBS2HDSDHD REFSD REF
SDLMAC IN
IJKALARM
OUTPUTSYNC OUTPUTNO
COMMUNICATIONINPUSHRTSOUTCH�1CMIC OUTH�2DIGITAL AUDIOTRUNKWFM CONTROL
CSU / MSU
VW
ROPZGND
AUX
\
X]
^
PQRSTUY
W Waveform monitor control connector [WFM CTL]X AUX connector [AUX]
This connector is used for controlling the waveform monitor.This connector is for establishing the down-converter
Since the interface is different, first check the WFM settingmode from the external system by remote control.
on the SYSTEM menu of the ROP or MSU before connect-Side panel, squeeze and letter-box are available as the
ing the waveform monitor.down-converter modes.
Waveform monitor control connector (SDAB-9S made byAUX connector (SDAB-9S made by Hirose)
Hirose)
Pin No.SignalFunction
PinFunction used byFunction used by
Signal1GND
No.SDTVHDTV
2MODE2
10 V output/input5 V pull-up, 110 kWhen shorted: 4:3 aspect ratio
1STAIRCASE
channel switchingWhen open: 16:9 aspect ratio
3MODE2
TTL level lowTTL level low
4MODE1
when SEQ isRefer to table below for the down
RGBselected by moni-5MODE1converter mode.
2
ENABLEtor selector switch
on ROP or MSU,6N.C.
for parade display
7TALLY RContact
TTL level low when
8TALLY GContact
THREE LINEENC.SEQ is selected
3Open
OR FIELDby monitor selector
9TALLY COM
switch on ROP or MSU
4N.C.Not connectedNot connected
Down-converter modeMODE1MODE2
TTL level low when G
LOCALOPENOPEN
or SEQ is selected by
5CH1Open
monitor selector switchLetter-box (LB)MAKEOPEN
on ROP or MSU
Squeeze (SQ)OPENMAKE
TTL level low when B
or SEQ is selected bySide panel (SP)MAKEMAKE
6CH2Open
monitor selector switch
on ROP or MSU
TTL level low when R
or SEQ is selected by
7CH3Open
monitor selector switch
on ROP or MSU
8N.C.Not connectedNot connected
9GNDGNDGND
8 |
ACEC
PANASONIC
