3gb66053.fm Page 50 Wednesday, March 3, 2004 5:41 PM
INSTALLATION
Electrical connection
The electrical connections must comply with local
regulations.
The data relevant to the voltage and power absorption are L
indicated on the rating plate.
The earthing of this appliance is compulsory by law.Earth
The manufacturer cannot be held responsible for any (Yellow/
injury to persons or animals or damage to property
arising from failure to comply with these requirements.N
When the cooktop is installed, provide a single-pole
circuit breaker with a contact separation of at least 3
mm.
If necessary, the electrical power cable must be
replaced exclusively with a power cable having identical
characteristics to the original supplied by the
manufacturer (type HO5V2V2H2-F - T90°C or type
HO5RR-F) and the earth wire must be 20 mm longer
than the others. This operation must be performed by
the After Sales Service or a qualified electrician.
Connection to gas supply
The gas supply system must comply with local
regulations.
You can find specific local regulations for some countries, in the
separate National Safety Regulations Sheet supplied.
If no information concerning your Country is given, please ask
details to your Installer.
The connection of the cooktop to the gas pipe network or gas
cylinder must be made by means of a rigid copper or steel pipe
with fittings complying with local regulations, or by means of a
continuous-surface stainless steel hose complying with local
regulations.
Connection with rigid copper pipe
The connection to the gas pipe network must be performed
taking care not to cause undue stress to the appliance.
The connection can be made using adaptor unit D with bicone,
interposing the washer C supplied.
Connection with stainless steel flexible hose
Use continuous-surface stainless steel hoses only, interposing
the washer C supplied, between fitting A and hose B.
Note: The maximum length of the hose is 2 m.
Attention: if a stainless steel hose is used, it must be
installed so as not to touch any mobile part of the
furniture. It must pass through an area where there are
no obstructions and where it is possible to inspect it on all
its length.
After connection to the gas supply, check for leaks with
soapy water.
Attention: Should you experience difficulty in turning the
burners knobs, please contact the After Sales Service for
the replacement of the burner tap.
50 |
ACEC
WHIRLPOOL
