75007Agb.fm5 Page 10 Monday, March 26, 2001 5:21 PM
AFTER SALES SERVICE
Before calling After Sales Service:? The service code (number below
the word SERVICE on the rating
1. Check to see if you can fix the problem
plate inside the hood behind the
yourself (see ?Troubleshooting guide?).
grease filter).
2. Switch off the hood for a few minutes and
re-start it to see if the problem has cleared itself.
3. If the malfunction persists, call
After-Sales Service.
Specify:
? The nature of the problem.? Your full address.
? The model.? Your telephone number and area code.
INSTALLATION
When installing the hood, the minimum distances from the cooktop must be respected, and
the numerical sequence and additional instructions must be followed exactly as indicated on
the Installation sheet.
EXTERNAL EXHAUST MODEAIR CIRCULATION MODE
(A - see also instruction sheet)(F - see also installation sheet)
Cooking fumes and vapours are conveyedThe air is filtered by a carbon filter and recycled
outside through a duct connected to the hood into thby e surrounding atmosphere. The filtered air
means of a collar.is released towards the kitchen ceiling.
The outlet duct diameter must be the same as
Warning! If the hood does not have a carbon
that of the collar.
filter, order one and fit it before use.
If a flue-damper is to be installed, check that
Check that the switch inside the hood (if fitted) is
it can open and close freely when installation
on position ?F? Filt; if noert, set it to this position.
of the exhaust duct is complete.
If the plug is provided, close off the upper
The hood can be supplied with one (upper) or
exhaust hole.
two (upper and rear) exhaust outlet holes.
The hood is usually set up for using the ELECTRICAL CONNECTION
upper exhaust outlet.Before connecting the hood, make sure the
voltage indicated on the rating plate corresponds
1. The collar must be seated in the upper
exhaust outlet.to the voltage in your home.
The plate is located inside the hood behind
Use the rear exhaust outlet (where present).the grille.
1. Where fitted, remove the cover closing off For GB tthhe is appliance is supplied without a plug
rear outlet and collar.and is intended for direct connection to fixed
2. Some models are fitted with a plastic wiring in accordance with national wiring
regulations. An all-pole disconnection switch
deflector that closes off the rear outlet.
with a minimum contact separation of 3 mm must
If fitted, remove it.
be included in the fixed wiring in an easily
3. Fit the collar in the rear outlet.
accessible position.
4. Put the cover (if fitted) in the upper outlet.
The Manufacturer shall not be liable for
any damage or problem arising from
Warning! If the hood has a carbon filter, this
the failure to comply with the
should be removed.
above-mentioned instructions.
Check that the switch inside the hood (if fitted)
is in position ?A? Extractor; if not, set it to
this position.
10 |
ACEC
WHIRLPOOL
