AM-400DE
[4] Error code table
1. Communication error code table
1.1. G3 Transmission
CodeFinal received signalError Condition (Receiver side)
0Incomplete signal frameCannot recognize bit stream after flag
1NSF, DISCannot recognize DCS signal by echo etc.
Cannot recognize NSS signal (FIF code etc.)
2CFRDisconnects line during reception (carrier missing etc.)
3FTTDisconnects line by fall back
4MCFDisconnects line during reception of multi page
Cannot recognize NSS, DCS signal in the case of mode change
5PIP or PINThe line is hung up without replying to telephone request from the receiving party.
6RTN or RTPCannot recognize NSS, DCS signal after transmit RTN or RTP signal.
7No signal or DCNNo response in receiver side or DCN signal received* (transmitter side)
8-Owing to error in some page the error could not be corrected although the specified number of
error retransmissions were attempted.
11-Error occurred after or while reception by the remote (receiving) machine was revealed to be
impossible.
12-Error occurred just after fallback.
13-Error occurred after a response to retransmission end command was received.
1.2. G3 Reception
CodeFinal received signalError Condition (Receiver side)
0Incomplete signal frameCannot recognize bit stream after flag
1NSS, DCSCannot recognize CFR or FTT signal
Disconnects line during transmission (line error)
2NSC, DTCCannot recognize NSS signal (FIF code etc.)
3EOPCannot recognize MCF, PIP, PIN, RTN, RTP signal
4EOMCannot recognize MCF, PIP, PIN, RTN, RTP signal in the case of mode change
5MPSThe line is hung up without replying to communication request.
6PR1-QCannot recognize PIP, PIN signal in the case of TALK request
7No signal or DCNNo response in transmitter (cannot recognize DIS signal) or DCN signal received* (receiver side)
8-Error occurred upon completion of reception of all pages.
9-Error occurred when mode was changed or Transmission/Reception switching was performed.
10-Error occurred during partial page or physical page reception.
11-Error occurred after or during inquiry from the remote (transmitting) machine as to whether recep-
tion is possible or not.
12-Error occurred during or just after fallback.
13-Error occurred after the retransmission end command was received.
1.3. Super G3 mode1.4. <Reference> Details of E-29 ~ E31
Error CodeTransmission ErrorsReception ErrorsE-29Handshaking error in V.8 negotiation procedure
E-16Same as E-0Same as E-0E-30Handshaking error in V.34 line probing procedure
E-17Same as E-1Same as E-1E-31Handshaking error in V.34 HDX training procedure
E-18Same as E-2Same as E-2
E-19-Same as E-8
E-20Same as E-4Same as E-9
E-21-Same as E-10
E-22--
E-23Same as E-7Same as E-7
E-24Same as E-8-
E-25Same as E-11Same as E-11
E-26Same as E-12Same as E-12
E-27Same as E-13Same as E-13
E-28--
E-29
Error occurred during handshaking for super G3
E-30
mode
E-31
2 - 31 |
ACEC
SHARP
