Main Sub
Content
codecode
2501 Main motor operation check (Cooling fan motor rotation check)
When the PRINT switch is pressed, the main motor (as well as the duplex motor in the duplex model) is operated for 30 sec. If the
developing unit is installed at that time, the developing bias, the main charger, and the grid are outputted together in order to avoid
toner consumption. Since, in this case, laser discharge is required when stopping the motor, the polygon motor is rotated at the same
time. If the developing unit is not installed, the above high voltage is not outputted and only the motor is rotated.
: Do not execute this simulation by forcibly turning ON the door ON/OFF switch.
10 Polygon motor ON
(Operation/Procedure)
When the START key is pressed, the polygon motor is operated for 30 sec.
2601 Manual feed setup
(Operation/Procedure)
1. When this simulation is executed, the currently set bypass code number is displayed.
2. Enter the code number corresponding to the bypass and press the START key, and the setting will be changed.
Code numberBypass
0Single bypass
1Multi bypass
02 (R) SPF setup
When this simulation is executed, the current setup of the SPF code number is displayed. Enter the code number corresponding to the
SPF and press the PRINT switch to enable the setup.
Code numberSPF
0SPF not installed
1SPF installed
2RSPF installed
03 Second cassette setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of the second cassette is displayed.
2. Enter the code number and press the start key. The setting is changed.
Code numberSecond cassette
0Without second cassette
1With second cassette
04 Machine duplex setup
(Operation/Procedure)
1. When this simulation is executed, the currently set duplex code number is displayed.
2. Enter the code number corresponding to the duplex and press the ENTER key, and the setup will be changed.
Code numberDuplex
0Without Duplex
1With Duplex
06 Destination setup
When this simulation is executed, the current setup of the destination code number is displayed. Enter the code number corresponding
to the destination and press the PRINT switch to enable the setup.
Code numberDestination
0Inch series
1EX JAPAN AB series
2JAPAN AB series
3China (EX JAPAN AB series + Chinese paper support)
07 Machine conditions check
When this simulation is executed, the current machine setup is displayed.
CPMCopy quantity display
10 cpm 10
12 cpm 12
13 cpm13
14 cpm14
15 cpm 15
AR-122E/152E/153E/157E SIMULATION, TROUBLE CODES 10 - 6 |
ACEC
SHARP
