ROLAND AR-200 Instruction Manual

AR-200_e.book 32 Z
8
?
?
?
??
?e
?
?xýe
Uxý9=
?p
?
? 
Controlling the AR-200 from an External Device (Control Input Connectors)
Operational Specifications of Procedure for Setting the Control Input Mode
Binary Playback1.Turn off the power of the AR-200.
Basic Operation of Binary Playback2.Set the MODE switches on the AR-200Os bottom panel as
shown below.
fig.inp-16
Binary Specification0001SW1: OFFPort No.1--8
SW2: ON
START Port3.Turn on the power of the AR-200.
* Use a pointed object to change the ON/OFF settings of the
MODE switches.AUDIO OUTPUT0001
Playback:
Specify the phrases using combinations of 0 (Off) and 1 (On) To Specify Phrases with Binary
signals to Port Nos. 1 through 8, and Port Nos. 11 and 12, and
input a control signal to the Port No. 9 (START).Signals
? This plays back the specified phrase.Example: Specifying Phrase 0112 (Phrase #: 0112)
Stopping:1.Convert the phrase number to a binary signal number.
Input a control signal to Port No. 10 (STOP).�0� (Off)
? This stops playback of the phrase.
�1� (On)
The basic operation of Binary Playback is shown below.
fig.inp-17
Binary Specification00010002 0003Phrase Number/Binary Signal Correspondence Table (p. 36)Port No.1--8
The phrase number O0012� becomes the binary signal
O01110000.�Disabled
START Port
With the above step, Phrase No. 0112 is converted to:
0001 000100020003fig.inp-18AUDIO OUTPUT
Binary specified phrases are played back repeatedly.Port No. 8 7 6 5 4 3 2 1
Playback is repeated while the start signal is continuously INPUT Signal 0 1 1 1 0 0 0 0
input.Phrase Number (Binary)
You can begin playback of phrases by specifying phrases in
binary with the start signal continuously being input.
Input of binary specifications should be completed in no
When the START connector control signal switches to Off, more than 50 milliseconds.
the current phrase finishes, and then playback is stopped.
No action results when a new start signal is input while a
phrase is being played back.
AR-200 Settings
Selecting the Control Input Mode
Set the MODE switches on the AR-200Os bottom panel to
select OBINARY PLAYBACK� from the control input modes
(PLAYBACK BY CARD DATA/DIRECT PLAYBACK/
BINARY PLAYBACK/INTERVAL PLAYBACK).
* You cannot achieve control input playback merely by
connecting a device to the port. Be sure to set the control input
mode and match the method used for connecting to the
connectors.
32