Main Sub
TitleFinisher staple trouble (Finisher side detection)
codecode
Phenomenon DisplayLamp
F1 10
Message
DetailThe staple home position sensor signal OFF is not recognized within the specified time after output
of the staple motor ON signal. / Though the staple home position sensor OFF signal is recognized
after output of the staple motor ON signal, but the staple home position sensor ON signal is not
recognized within the specified time.
SectionFinisher stapler
Operation modeStapling
NOTE
Case 1Trouble position /Staple motor trouble / Staple home position sensor trouble
Cause
Remedy (Check) Check the operation of the staple motor/staple home position sensor. (SIM 3-1/2)
(Repair) Replace the staple motor. / Replace the staple home position sensor. / Power OFF-ON
(After work)
Case 2Trouble position /Staple unit mechanism section trouble
Cause
Remedy (Check) Check the staple unit mechanism section operation. (SIM 3-1/2)
(Repair) Replace or repair the staple unit. / Power OFF-ON
(After work)
Case 3Trouble position /Finisher control PWB trouble
Cause
Remedy (Check) (SIM3-1/2) Check the finisher control PWB operation. (SIM 3-1/2)
(Repair) Replace the finisher control PWB. / Power OFF-ON
(After work) Make various adjustments related to the finisher electric section. (Install the EEPROM
of the defective finisher control PWB to a new finisher control PWB.)
Main Sub
TitleFinisher bundle process trouble (Finisher side detection)
codecode
Phenomenon DisplayLamp
F1 11
Message
DetailIn the initial operation, the return roller home position sensor signal ON is not recognized within the
specified time after starting rotation of the return roller. / In the initial operation, the bundle exit belt
home position sensor OFF is not recognized within the specified time after starting bundle exit
operation. / In the initial operation, the bundle exit belt home position sensor signal ON is not
recognized within the specified time after starting bundle exit operation.
SectionFinisher paper exit
Operation modePower ON / Initial operation
NOTE
Case 1Trouble position /Bundle process motor trouble / Return roller home position sensor trouble
Cause
Remedy (Check) Check operations of the bundle process motor/return roller home position sensor. (SIM
3-1/2)
(Repair) Replace the bundle process motor. / Replace the return roller home position sensor. /
Power OFF-ON
(After work)
Case 2Trouble position /Return roller mechanism section trouble
Cause
Remedy (Check) Return roller mechanism section (SIM 3-1/2)
(Repair) Repair the return roller mechanism section. / Power OFF-ON
(After work)
Case 3Trouble position /Finisher control PWB trouble
Cause
Remedy (Check) Check the finisher control PWB operation. (SIM 3-1/2)
(Repair) Replace the finisher control PWB. / Power OFF-ON
(After work) Make various adjustments related to the finisher electric section. (Install the EEPROM
of the defective finisher control PWB to a new finisher control PWB.)
10 � 8 |
ACEC
SHARP
