3 Change the set value.
[EXECUTE]With the above operation,
the set value can be changed.
Set value
<Example>
AWhen setting to one-digit value (5)
5[EXECUTE]
AWhen setting to two-digit value (15)
15[EXECUTE]
When the value is changed by 1, the center position is shifted by
about 0.12mm.
HReference of set value change
0(Shipment setting value)99
The image is shifted to the front The image is shifted to the rear
of the paper.of the paper.
4 After adjustment, make a copy to check the center is not shifted.
If the center is shifted, repeat procedures 3 and 4 and check
again.
5 After adjustment, press the CA key to cancel the setting mode.
� 4 � |
ACEC
SHARP
