ADJ 2Resist amount adjustmentADJ 2BAdjustment in the print lead edge
adjustment mode
ADJ 2AAdjustment in the resist amount 1) Enter the SIM 50-05 mode
adjustment mode
1) Enter the SIM 51-02 mode.
2) Select the adjustment mode (DEN-B/DEN-C) with the scroll
key.
2) Select the ?B: LCC? with the scroll key.Display ContentSet range Default
A DEN-CSub scanning print 1 - 9940
lead edge adjustment
B DEN-BSub scanning print 1 - 9940
area adjustment
C MULTI COUNT Print quantity1 - 9991
D PAPERPaper feed tray 1 - 62
selection (MFT, CS1, (CS1)
CS2, CS3, CS4, LCC)
3) Enter the adjustment value with the 10-key.E EXIT TRAYPaper exit tray 1 - 21 (R)
selection (R, S)
DisplayContentSet range Default
FDuplex print selection 1 - 21 (NO)
B LCCLCC tray deflection 1 - 9910DUPLEX
(NO, YES)
adjustment value
3) Enter the adjustment value of the selected point with the 10-
The smaller the set value is, the smaller the deflection quantity.
key, and press the [OK] key. (The entered adjustment value is
The greater the set value is, the greater the deflection quantity.
set. The [EXECUTE] key or the scroll key can be used instead
Adjustment unit: Time in the unit of 1ms (The reference speed is
of the [OK] key in the above procedure.)
117mm/s. Variable according to the speed.)
4) Press the [OK] key.
The entered adjustment value is set.
4) Select the paper feed mode "D: 6 (LCC)", and press the [EXE-
CUTE] key.
The test pattern corresponding to the entered adjustment
value is printed.
When the adjustment value of item A (DEN-C) is decreased by
1, the print start position in the sub scanning direction shifts
0.125mm toward the paper lead edge.
When the adjustment value of item B (DEN-B) is decreased by
1, the print area in the sub scanning direction shifts 0.125mm
toward the paper rear edge.
AR-LC8 ADJUSTMENTS 7 - 2 |
ACEC
SHARP
