AR-PB9M
Operations when both of USB/parallel ports are connected at the same time.
The USB port has a priority over the parallel port.
Smartsharing is invalid.
Interface connected previouslyInterface connected laterOperation
USB: Enable
USB (Unfinished print job YES/NO)Parallel port
Parallel port: Disable
When USB is connected after 30sec of no communication through the
parallel port, the mode is shifted to the USB mode instantaneously.
Parallel port (Unfinished print job
USBIf no communication state does not reach 30sec yet, shifting to the USB
YES/NO)
mode is retained until 30sec passes. During that time, print jobs are
performed through the parallel port.
After completion of unfinished print jobs, if there is no communication for
Parallel port (Unfinished print job
USB30sec, shifting to the USB mode is made.
YES/NO)
Within 30sec, print jobs are performed through the parallel port.
2. Control panel
The following are the components of the control panel.The table below lists the functions of the LEDs:
LED
StateDescription
name
The printer unit is not ready to receive
Unlitdata.
ONLINE(Offline status)
The printer unit is ready to receive data.
Lit
(Online status)
No data is being received or processed.
Unlit
(No print job is being processed)
DATAThe printer data is being received or
Litprocessed or Printed.
The table below lists the functions of the keys:
(A print job is being processed.)
KeyFunctionsFlashPrinter data is remained without printing.
If pressed when the machine is in online status:
If no print job is being processed (DATA LED unlit),The table below shows the initial states of the LEDs just after the
power is turned ON.
pressing the LINE key produces the offline. If ?Data
Loss Error? or ?Memory Full? was displayed, pressing
LED
the LINE key is disregarded.Initial state
names
If a 1-sided print job is being processed (Data LED lit or
ONLINELit (online)
LINEflashing), pressing the LINE key produces the offline. If
?Data Loss Error? or ?Memory Full? was displayed,Unlit
pressing the LINE key is disregarded.DATAWill light immediately, however, if data has already
arrived when the power is turned ON.
If a 2-sided print job is being processed (Data LED lit or
flashing), pressing the LINE key has no effect.
If pressed when the machine is in the offline status:
Pressing the LINE key produces the online status and
causes the display mode to Online Display Mode.
1 - 2 |
ACEC
SHARP
