14) Remove the fixing tape.AWhen the set value is decreased, the image is shifted to the
front side.
Remove the fixing tape.
Center line of image
Center line
of paper
After completion of the adjustment, press theCAkey to cancel the
mode.
17) Perform the lead edge adjustment.
Set a document on the automatic document feeder and make a copy.
Insert the power plug of the copier to the power outlet,Then set document on the document glass and make a copy.
turn on the power switch, and perform the following* If the lead edge of the copy image made with the automatic docu-
procedures.ment feeder is shifted from that made with the document glass,
15) Perform the magnification ratio adjustment.perform the following adjustment.
1. Execute SIM 52-16 with the key operations on the copier.
Set a document on the automatic document feeder and make a copy.
Then set a document on the document glass and make a copy.
* If the copy magnification ratio of the copy made with the automatic
document feeder is shifted compared with the copy image made[Program key]C05216
with the document glass, perform the following procedure.
1. Execute SIM 48-5 with the key operations on the copier.
2. Select the SPF item on the display with [Â] and [?] keys.
3. Enter the set value with the keys on the operation panel to per-
form the lead edge adjustment, and make a copy to check that[Program key]C04805
the lead edge is not shifted.
AWhen the set value is increased, the copy image moves for-
ward.
2. Enter the set value with the keys on the operation panel to per-
form the magnification ratio adjustment, and make a copy with theAWhen the set value is decreased, the copy image moves back-
automatic document feeder again to check that the magnificationward.
ratio is proper.After completion of the adjustment, press theCAkey to cancel the
mode.
After completion of the adjustment, press theCAkey to cancel the
mode.
16) Perform the center shift adjustment.
Set a document on the automatic document feeder and make a copy.
* If the center of the copy image is shifted, perform the following
procedure.
1. Execute SIM 50-16 with the key operations on the copier.
[Program key]C05016
2. Enter the set value with the keys on the operation panel to per-
form the center shift adjustment, and make a copy again to check
that the center is not shifted.
AWhen the set value is increased, the image is shifted to the
rear side.
Center line of image
Center line
of paper
� 4 � |
ACEC
SHARP
