AR-SS2
7) Check the status of the manual staple key.B. Bin roller height adjustment
ON:Adjustment completionThe dummy roller lower is of eccentric shape so that you can adjust
Blinking: Adjustment errorthe height of the bin roller this is so you can adjust the height at which
8) When the manual staple key blinks, check the installing conditionthe bin roller and the lead cam tip touch.
of the guide bar home position sensor, and perform the adjust-When the bin roller is replaced or reassembled, check the standard
ment from procedure 4) again.dimensions and change and adjust the installing angle of the dummy
9) After completion of the adjustment, return the DIP switch (SW1)roller lower if necessary.
on the sorter controller PWB to the original state.1) Adjustment procedure
Stand up the bin unit straight. Measure the distance between the
D. Stapler unit oscillation position adjustmentupper dummy roller (1) and the bin roller (2). If the distance is too
(Staple position adjustment)large, rotate the lower dummy roller (3) counterclockwise. If the
This adjustment is performed when the following parts are replaced.distance is too small, turn it clockwise. Turn and adjust so that the
ASorter controller PWBdistance is about 97.8mm.
AStapler unit oscillation motor
AStapler oscillation unit21
<Operating procedure>
1) Remove all the paper from the bins. Remove the right cover.
2) Set the DIP switch (SW1) on the sorter controller PWB as shown
below.
LED SW1 SW2 SW397.8mm
ON1
123456
3) Place 5 sheets of A4 or letter paper in the first bin as shown
below.
4) Press the push switch (SW3) on the sorter controller PWB to shift
the stapler oscillation unit to the stapling position.
3
5) Press the push switch (SW2) on the sorter controller PWB and
press the manual staple key to staple and check the stapling
position.
3. Guide bar parallelism adjustment
When the bin unit is disassembled or the top screw of the guide bar is
removed, adjust the guide bar parallelism.
Transport direction1) Adjustment procedure
Set B5 paper or A4R paper in the 1st bin and in the 20th bin.
Push the guide bar (1) manually in the alignment direction to press
it onto the paper.
Check contact conditions of the guide bar and the paper in the 1st
bin and the 20th bin. If they are not parallel, loosen the screw (3)
Stapleof the guide bar holder (2).
23
6 2.5mm
6) If the stapling position is outside the specified range, adjust the
stapling position with the push switch (SW3).
Press the staple key of the sorter. The stapler oscillation unit
returns to the home position and the adjustment value is stored.
7) Return the DIP switch (SW1) to the original state and install the1
right cover.
2. Mechanical system
A. Process for major parts replacement
Major partsProcess
Bin, bin roller1) Bin roller height adjustment
2) Guide bar parallelism
adjustment
5 � 2 |
ACEC
SHARP
