AR-TR2
10)Install the separator motor unit.13)Install the front cabinet and the right cabinet of the copier.
AInsert the separator motor unit into the positioning place and fixAInstall the right cabinet to the original position, and fix it with the
it with the screw. At that time, check that the grounding plate isfive screws. Connect the flat cable to the operation panel, and
at the position shown in the figure of the frame below.install the front cabinet to the original position. and fix it with the
12 screws. Close the original cover.
14)Install the front cover.
APress the both sides of the front cover inward to bend the
cover, and install it to the hinge arm. Close the paper cassette.
11)Connect the connector and store it.
AConnect the separator motor connector with the copier side
connector, and store them as shown.
15)Install the developing unit.
AHold the developing unit knob, and insert it slowly until it stops.
12)Install the ATC spacer.
APress the pawl on the right side of the fan to remove the fan.
Attach the ATC spacer to the shaft, and fix it to the position
shown below so that the clearance comes in front. Return and
fix the fan to the original position.
Knob
16)Install the right door of the copier and close the front cover and
the tray.
AInstall the right door, then close the tray and the front cover.
Pawl
1 � 3 |
ACEC
SAMSUNG
