KEY OPERATOR PROGRAM LIST
Using the key operator programs
The general procedure for using key operator programs is explained below, using "KEY OPERATOR CODE
CHANGE" as an example.
NOTE
To use the key operator programs, you must first program a key operator code number. (See steps 3 and 4 below.)
Press the [MENU] key repeatedly untilPress the [ ] or [ ] key to select the
16
"KEY OPERATOR PROGRAMS" appears.desired setting for the program, and then
press the [OK] key.
The settings of each
program are explained
on page 6 and following.
Press the [OK] key.
Example:"KEY OPERATOR CODE CHANGE" is
2
selected
In this example, the key operator code is changed
from 0000 (the factory default code) to 98765.
Select "KEY OPERATOR CODE CHANGE" in step 6
and press the [OK] key. The display shows the
following:
SET CODE
00000 - -----
This message willENTER KEY OPERATOR Follow steps 1 through 5 below to enter 98765.
CODE -----appear.
Press the [ ] or [ ] key until 9 appears and then
1
press the [OK] key. The second "-" begins to
Press the [ ] or [ ] key repeatedly until
blink.
3
the first digit of your key operator code
SET CODE
number appears, and then press the [OK]
00000 - 9----
key.
The factory defaultPress the [ ] or [ ] key until 8 appears and then
ENTER KEY OPERATOR 2
CODE 0----setting for the keypress the [OK] key. The third "-" begins to blink.
operator code number is
SET CODE
00000.
00000 - 98---
When you press the [OK] key to enter the first digit
Press the [ ] or [ ] key until 7 appears and then
after selecting it, "-" in the first digit will change to3
press the [OK] key. The fourth "-" begins to blink.
" " and "-" in the second digit will blink. If you need
to correct the previous digit, press the [BACK/C]
SET CODE
key to move back. 00000 - 987--
Repeat step 3 to enter the second throughPress the [ ] or [ ] key until 6 appears and then
44
the fifth digits of your key operator codepress the [OK] key. The fifth "-" begins to blink.
and then press the [OK] key.
SET CODE
00000 - 9876-
Press the [ ] or [ ] key until the desired
5
program appears and then press the [OK]Press the [ ] or [ ] key until 5 appears and then
5
press the [OK] key.
key.
Example:SET CODE
To change the key 00000 - 98765
operator code number,
select "KEY
The key operator code changes to the new code.
OPERATOR CODE
CHANGE" and thenTo exit the program, press the [MENU] key.
press the [OK] key.7
3 |
ACEC
SHARP
