Disposal of old AppliancesInstallation Location
For environmental reasons, refrigeration appliances must be disposed ofThis appliance should only be installed at a location where the ambient
properly. This applies to your old appliance, and - at the end of its servicetemperature corresponds to the climate classification indicated on the rat-
life - to your new appliance as well.ing plate, which is located on the inside left of the appliance.
Warning! Before disposing of old appliances make them inoperable.The following table shows which ambient temperature is correct for each
Remove plug from mains, sever the power cable, remove or destroy anyclimate classification.
snap or latch closures, to prevent small children being trapped inside.
Y Contact your local Council or Environmental Health Office to see if thereClimate classificationfor an ambient temperature of
are facilities in your area to recycle the appliance.
SN+10 to +32 !C
N+16 to +32 !C
Remove transport packaging
The appliance should be located in a dry atmosphere, out of direct sunlight
The appliance and the interior fittings are protected for transport.and away from continuous heat and extreme temperature, e.g. not next to
a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem-
Y Remove all adhesive tape and packing pieces from the interior of theperatures are exceeded i.e. warmer or colder, then the appliance may not
appliance.operate correctly.
For building-in and door reversal instructions please refer to the relevant
instructions.
Your appliance needs air
For safety reasons, minimum50
ventilation must be as shown
Fig.
Attention: keep ventilation556542
openings clear of obstruction;
880560 min.
873
619 |
ACEC
AEG
