STATUS INDICATORSSTATUS INDICATORSSTATUS INDICATORSSTATUS INDICATORSSTATUS INDICATORS
Be sure to use only genuine SHARP parts
and supplies.
When the following indicators light up or blink on the operation panel or the following symbols appear in the display,
solve the problem immediately referring to both the table below and the relevant page.
IndicationIndicationIndicationIndicationIndicationCause and remedyCause and remedyCause and remedyCause and remedyCause and remedy
Developer replacementSteadilyqDeveloper is required. Contact your SHARP service centre as soon
required indicator litas possible.
Toner cartridge replace-SteadilyReplacement of toner cartridge will be needed soon. Obtain a
ment required indicatorlitnew cartridge. p. 1-20
s
BlinkingToner cartridge must be replaced. Replace it with a new one.
p. 1-20
Misfeed indicator BlinkingA misfeed has occurred. Remove the misfed paper referring to
t
the description of ?Misfeed removal.? p. 1-23. Lever of fusing area
is not raised. p. 1-24 The lower side cover may be open. If so, close it.
SPF / R-SPF misfeedBlinkingAn original misfeed has occurred in the SPF or in the R-SPF.
indicatorRemove the misfed originals referring to the description of
"Misfeed in the SPF or in the R-SPF". p. 1-26.
Maintenance indicatorSteadilyService by an authorized SHARP service technician is required.
litp.1-25.
qThe paper tray indicatorThe paper tray is not installed properly. Push the tray into the
is blinking.copier securely. p.1-7.
?CH ? is blinking inThe toner cartridge is not installed. Install the toner cartridge.
nthe display.If ?CH ? is blinking even if the cartridge is installed properly,
contact your SHARP service centre immediately. p. 1-20
?CH ? is steadily lit inSide cover is open. Close the side cover securely by pressing the
the display.round projections near the side cover open button. p. 1-21
?P? is blinking inPaper tray or bypass tray is empty. Load copy paper. p. 1-7
Q
the display.
A misfeed has occurred in the paper tray or bypass tray. Remo-
ve the misfed paper. p. 1-24
Paper tray is not securely installed. Push the tray in securely.
p. 1-7
A letter and a numberThe copier will not function. Turn the power switch off and thenHGB
appear alternately.switch it on,and if there is again an error, remove the power cord
from the outlet, and contact your authorized Service representative.
The memory backup funtion for facsimile maintains data only for one hour. When any facsimile data
is kept in memory,do not keep the copier power turned off (by unplugging the power cable) for a long
time even if the copier stops due to trouble. (AR-F152)
DISPLAYING TOTAL NUMBER OF COPIESDISPLAYING TOTAL NUMBER OF COPIESDISPLAYING TOTAL NUMBER OF COPIESDISPLAYING TOTAL NUMBER OF COPIESDISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
1. Press the clear (>) key to reset the
display to zero.
2. Press and hold down the clear (>) key
for approximately 5 seconds. The total
number of copies will appear in two
steps, each with three digits.
Example:
Total number of copies is 1,234.
11111 ----- 2929292929
AR-151 156 F152 121E 151E NON EU GB-H 1.p652909/01/01, 11:43 |
ACEC
SHARP
