3.2 REMOVING THE CRT
CRT CHANGE TABLE
NOTE:
? Replacement of the CRT should be performed by 2 or more
persons.
? After removing the REAR COVER, CHASSIS etc.,
APPROX.
(1) Putting the CRT change table on soft cloth, the CRT35cm
change table should also be covered with such soft cloth
(shown in Fig. 3). CLOTH
(2) While keeping the surface of CRT down, mount the TV set
on the CRT change table balanced will as shown in Fig. 3.
(3) Remove 4 screws marked by arrows with a box type
screwdriver as shown in Fig. 4.Fig.3
NOTE:
CRT
Since the cabinet will drop when screws have been
removed, be sure to support the cabinet with hands.
(4) After 4 screws have been removed, put the cabinet slowly
on cloth (At this time, be carefully so as not to damage theCRT
CHANGE
front
TABLE
surface of the cabinet) shown in Fig. 5.
BOX
NOTE:TYPE
SCREW
? The CRT should be assembled according to theDRIVER
opposite sequence of its dismounting steps.
? The CRT change table should preferably be smaller
that the CRT surface, and its height be about 35cm. Fig.4
CRT
CRTCABINET
CHANGE TABLE
Fig.5
(No.52121)1-11 |
ACEC
JVC
