YFor power saving purposes, the receiver can be
Precautionscompletely turned off by the POWER button on
the main unit. Though the LED remains lit for a
while, the receiver is completely off.
On safety
Should any solid object or liquid fall into theOn adjusting volume
cabinet, unplug the receiver and have it checked
Do not turn up the volume while listening to a
by qualified personnel before operating it any
section with very low level inputs or no audio
further.
signals. If you do, the speakers may be damaged
when a peak level section is played.
On power sources
YThe unit is not disconnected from the AC power
On cleaning
source (mains) as long as it is connected to the
wall outlet, even if the unit itself has beenClean the cabinet, panel, and controls with a soft
turned off.cloth slightly moistened with a mild detergent
YAC power cord must be changed only at thesolution. Do not use any type of abrasive pad,
qualified service shop.scouring powder or solvent such as alcohol or
benzine.
On placement
If you have any questions or problems concerning
YPlace the receiver in a location with adequate
your receiver, please consult your nearest Sony
ventilation to prevent heat build-up in the
dealer.
receiver.
YAt high volume, over long periods of time, the
cabinet becomes hot to the touch. This is not aOn cleaning discs
malfunction. However, touching the cabinetDo not use a commercially available CD/DVD
should be avoided. Do not place the unit in acleaning disc. It may cause a malfunction.
confined space where ventilation is poor as this
may cause overheating.On your TVOs colour
YDo not block the ventilation slots by puttingIf the speakers should cause the TV screen to have
anything on the receiver. The receiver is
colour irregularity, turn off the TV at once then
equipped with a high power amplifier. If the
turn it on after 15 to 30 minutes. If colour
ventilation slots on the top surface are blocked,
irregularity should persist, place the speakers
the unit can overheat and malfunction.
further away from the set.YDo not place the receiver on a soft surface such
as a rug that might block the ventilation holes
on the bottom.IMPORTANT NOTICE
YDo not place the receiver in a location near heatCaution: This receiver is capable of holding a
sources, or in a place subject to direct sunlight,still video image or on-screen display image on
excessive dust, or mechanical shock.your television screen indefinitely. If you leave
the still video image or on-screen display image
On operation
displayed on your TV for an extended period of
YIf the receiver is brought directly from a cold to
time you risk permanent damage to your
a warm location, or is placed in a very damp
television screen. Projection televisions are
room, moisture may condense on the lenses
inside the receiver. Should this occur,especially susceptible to this. the
receiver may not operate properly. In this case,
remove the disc and leave the receiver turned on
for about half an hour until the moisture
evaporates.
YWhen you move the receiver, take out any discs.
If you donOt, the disc may be damaged.
GB
3 |
ACEC
SONY
