Section
Initial Settings20
Adjusting initial settingsSetting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
% Touch FM STEP on the initial menu to
select the FM tuning step.
Touching FM STEP will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
111lected FM tuning step will appear in the dis-
play.
Using the initial settings, you can customizeInitialSettings
various system settings to achieve optimal per-Note
formance from this unit.If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
1 Function displaytions with manual tuning or use seek tuning
Shows the function names.again.
1 Touch the source icon and then touch
OFF to turn this unit off.
Setting the AM tuning step
2 Touch the screen to display the touchThe AM tuning step can be switched between
panel keys.9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
3 Touch AV MENU to display the function
names.America, reset the tuning step from 9 kHz (531
The function names are displayed and oper-kHz to 1602 kHz allowable) to 10 kHz (530 kHz
able ones are highlighted.to 1640 kHz allowable).
# To go to the next group of function names,
touch NEXT.% Touch AM STEP on the initial menu to
# To return to the previous group of functionselect the AM tuning step.
names, touch PREV.Touching AM STEP will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
4 Touch ESC to return to the display ofAM tuning step will appear in the display.
each source.
# To return to the previous display, touch BACK.
Switching the warning tone
Note
You can use AUTO EQ&TA (auto-time alignmentIf the front panel is not detached from the
and auto-equalizing), only when STANDARD hashead unit within five seconds of turning off the
been selected in DSP MODE. (Refer to Switchingignition, a warning tone will sound. You can
the DSP setting mode on page 105.)turn off the warning tone.
En103 |
ACEC
PIONEER
